N4512Z

HISTORY OF FLIGHT

On June 9, 1994, about 1630 hours Pacific daylight time, a Piper PA28-161, N4512Z, collided with a Cessna T207A, N6383H, about 2 miles north of Banning, California. Both aircraft were being operated under visual flight rules (VFR) under Title 14 CFR Part 91. N4512Z, operated by Air Desert Pacific, La Verne, California, was destroyed. A noncertificated student pilot, the sole occupant, received fatal injuries. The accident flight departed the Blythe Airport, Blythe, California, about 1529 hours as the return portion of an authorized solo cross-country flight that originated at Brackett Field, La Verne, about 1200 hours. The pilot had filed a VFR flight plan. Visual meteorological conditions prevailed.

N6383H, operated by I.K. Curtis Services, Inc., Burbank, California, was destroyed by impact and postimpact fire. A certificated commercial pilot and a photography technician passenger received fatal injuries. The flight originated at the Burbank-Glendale-Pasadena Airport, Burbank, about 1149 hours as a photographic survey flight over areas in the San Fernando Valley, Banning, and San Diego. No flight plan was filed.

Witnesses reported that N4512Z was observed flying westbound about 1,000 feet above the ground (agl). The pilot had planned to stop at Banning airport as part of his cross-country solo flight. N6383H was observed to be maneuvering in the area in a left turn. The purpose of the flight was to photograph specific targets in the area of the accident. Each target specified an altitude of 1,200 feet above the ground. Due to differences in ground elevation, the aircraft's mean sea level altitude varied from 3,300 feet to 3,600 feet.

Just prior to impact, witnesses indicated that N4512Z appeared to begin an evasive maneuver by climbing. Following impact, both aircraft continued past each other about 500 feet and then spiral to the ground. Following ground impact, the wreckage of N6383H initiated about a 20-acre grass fire. The wreckage of N4512Z was located about 1/2 mile west of N6383H. The left wing of N4512Z was located about halfway between the two wreckage sites.

OTHER DAMAGE

About a 20-acre brushfire was ignited by the wreckage of N6383H. The fire damaged several buildings on the Morongo Indian Reservation.

CREW INFORMATION

The pilot of N4512Z was issued a student pilot/third-class medical certificate on December 4, 1991. The pilot held a current third-class medical certificate that was issued on April 14, 1994, and contained no limitations.

The pilot of N6383H held a commercial pilot certificate with airplane single-engine and multiengine land and instrument airplane ratings. The most recent first-class medical certificate was issued to the pilot on July 21, 1993, and contained no limitations.

AIRCRAFT INFORMATION

N4512Z had accumulated a total time in service of 5,431 flight hours. The most recent annual inspection was accomplished on June 1, 1994. N6383H had accumulated a total time in service of 8,545 flight hours. The most recent annual inspection was accomplished on March 25, 1994. Examination of the maintenance records for each aircraft revealed no unresolved maintenance discrepancies against either aircraft prior to departure.

METEOROLOGICAL INFORMATION

The closest official weather observation station is Beaumont, California, which is located 7 nautical miles west of the accident site. At 1646 hours, a surface observation was reporting in part: Sky condition and ceiling, clear; visibility, 3 miles in haze; temperature, 97 degrees F; dew point, 44 degrees F; wind, 320 degrees at 8 knots.

Palm Springs, California, is located 25 nautical miles east of the accident site. At 1536 hours, a surface observation was reporting in part: Sky condition and ceiling, clear; visibility, 25; temperature, 109 degrees F; wind, 120 degrees at 15 knots; altimeter, 29.74 inHg.

COMMUNICATIONS

The two aircraft were not in radar contact or voice communication with any known Federal Aviation Administration (FAA) air traffic control (ATC) facilities at the time of the accident. N4512Z had previously been receiving VFR traffic advisories from the Palm Springs, California, Terminal Radar Approach Control Facility (TRACON) from 1603 to 1624 hours. Advisory services had been terminated about 6 minutes before, approximately 7 miles east of the accident site.

AERODROME AND GROUND FACILITIES

The Banning Airport is located about 2 miles south of the accident site. The published elevation of the airport is 2,219 feet mean sea level (msl). The traffic pattern altitude is 3,219 feet, 1,000 feet above the ground (agl). The airport is equipped with a single hard-surfaced runway on a 080/260 degree magnetic orientation. The runway is 5,200 feet long by 150 feet wide. The airport/facility directory indicates that a right-hand traffic pattern (north of the airport) is utilized when landing on runway 26.

WRECKAGE AND IMPACT INFORMATION

N4512Z

National Transportation Safety Board investigators examined the wreckage of both aircraft at the accident site on June 10, 1994, and, after retrieval, at Aero Aviation, Compton, California, on June 11, 1994. Numerous segments of both airplane's wing structure were located scattered between the separated wing of N4512Z and the point of ground impact of N6383H. Additionally, numerous portions of both airplanes were located scattered up to about 1/4 mile south of the ground impact site of N6383H. N4512Z was painted white with blue and grey accent striping. N6383H was painted white with butterscotch and brown trim.

The left wing of N4512Z separated about 6 feet inboard from the wing tip faring attach point. The outboard wing tip faring was missing. The wing was located at latitude 33 degrees, 56.58 minutes North and longitude 116 degrees, 49.82 minutes West, about 1/4 mile east of the main fuselage. The wing is predominately painted white with a grey paint stripe oriented chordwise at the outboard end. A blue chordwise stripe is about 1 inch inboard from the grey stripe.

The inboard end of the separated wing displayed aft crushing, wrinkling, and upward curling of the inboard separated end, beginning about 1 inch inboard of the stall warning sensor. The wing spar exhibited aft bending and curling at the point of separation. Yellow/green paint transfers were noted on the underside of the wing, along the folded edges of the wing skin, and the forward face of the wing spar structure at the point of separation. About 2 feet of the outboard end of the aileron remained attached to the wing at the outboard hinge bracket. The trailing half of the wing structure, from the inboard separated end of the aileron, to the aft face of the wing spar in an inboard direction, was torn away and missing, exposing the aft face of the spar.

The underside of the separated wing exhibited three diagonal scratches with faint blue paint smudges oriented from the outboard leading edge corner towards the inboard trailing edge of the wing. The angle of scratch marks was measured in relation to the chordline of the wing. The most forward scratch was oriented at a 25-degree angle from the chordline. The next aft mark was oriented at a 52-degree angle and the most aft mark at a 30- degree angle. The outboard, underside of the leading edge, exhibited an indentation with diagonal scratches and blue smudges.

The airplane's main fuselage struck the ground at latitude 33 degrees, 56.64 minutes North and longitude 116 degrees, 50.18 minutes West on about a 045-degree heading. The right wing remained attached to the fuselage and exhibited extensive spanwise leading edge aft crushing and folding back to the wing spar. The leading edge also exhibited several semicircular aft crushing areas located about 6 feet, 10 feet, and 15 feet inboard from the outboard wing tip faring attach point. The aileron and flap remained attached to the wing.

The inboard portion of the left wing remained attached to the fuselage. It was extensively crushed and folded aft in a chordwise direction back to the wing spar and was broken at the inboard spar attach point. About 4 1/2 feet out from the inboard end of the wing, just outboard of the left main gear, is the point of wing separation; however, a 3 1/3-foot-segment of the wing spar was located lying adjacent to the inboard wing spar end. The outboard end of the wing spar and the inboard mating end of the spar segment exhibited upward bending and aft curling. The spar segment also exhibited "S"-type spanwise bending and torsional twisting. The wing skin and structure around the exposed spar segment was torn away and missing. The empennage was crushed and folded in a forward direction. The vertical stabilizer displayed semicircular aft crushing of the leading edge back to the rudder attach point. The rudder remained attached to the vertical stabilizer. The horizontal stabilizer and its trim tab assembly remained attached to the empennage. The upper portion of the airplane fuselage, from the top of the windshield to the vertical stabilizer attach point, was crushed and folded along the longitudinal axis of the aircraft. The entire upper portion of the roof area was located forward of the main fuselage, lying upside down. The upper fuselage surface had evidence of several blue paint smudges. The entire cabin and cockpit area was crushed, fragmented, and folded in a forward direction. The engine cowling was located about 300 yards east of the main fuselage. It exhibited tearing of the aft attach screws, wrinkling and crushing of the lower left side, and numerous blue paint smudges.

Due to the impact damage, Safety Board investigators were unable to operate the flight controls by their respective control mechanisms. The instrument panel was extensively crushed forward to the firewall and both were crushed under the engine.

The engine sustained extensive impact damage to the underside and front portion of ...