N1142S

Substantial
Serious

Schweizer SGS-1-26E S/N: 522

Accident Details

Date
Sunday, September 1, 1996
NTSB Number
IAD96LA142
Location
ELMIRA, NY
Event ID
20001208X06751
Aircraft Damage
Substantial
Highest Injury
Serious
Fatalities
0
Serious Injuries
1
Minor Injuries
0
Uninjured
0
Total Aboard
1

Probable Cause and Findings

the pilot's failure to maintain adequate altitude and airspeed during the landing approach, resulting in a stall/spin and subsequent encounter with an embankment.

Aircraft Information

Registration
Make
SCHWEIZER
Serial Number
522
Engine Type
None
Year Built
1972
Model / ICAO
SGS-1-26E
Aircraft Type
Glider
No. of Engines
0
Seats
1
FAA Model
SGS 1-26E

Registered Owner (Current)

Name
SCHWEIZER LESLIE E
Address
1411 BERANEK RD
City
CAYUTA
State / Zip Code
NY 14824-9739
Country
United States

Analysis

On September 1, 1996, at about 1409 eastern daylight time (EDT), N1142S, a Schweizer SGS-1-26E glider, overshot runway 17 during landing at Harris Hill Airport, in Elmira, New York. The student pilot, the sole occupant, was seriously injured. The airplane sustained substantial damage. Visual meteorological conditions prevailed and a flight plan was not filed. The local, instructional flight was conducted under 14 CFR Part 91, and originated from Elmira, New York, at 1320 EDT.

The pilot reported that she completed two successful landings and this was her third solo flight. She said, "...started my landing approach to runway 16 at Harris Hill with the idea of using a slip to lose altitude, if possible. On final I initiated a slip with the spoilers closed so I would not be too low. I then realized I was too low for a slip, but in terminating I ballooned and became concerned with completing successful landing on 16 due to being too high. I then decided to extend my glide path and turn East to land on Harris Hill's auxiliary runway located at the South end of the field. However, my altitude and airspeed were both too low to complete this maneuver...I skidded the glider with the rudder to avoid banking too steeply and this in combination with my low airspeed initiated a stall and spin to the left... ."

According to a Federal Aviation Administration (FAA) Safety Inspector, this was the pilot's third flight in this glider. The glider overshot the runway and slid down an embankment. The pilot stated that "there was no mechanical malfunction and the accident could have been prevented if she had maintained the proper pattern airspeed, flying coordinated at low airspeeds close to the ground, not changing runways at the last minute, and not using a forward slip too low on final with spoilers closed".

Data Source

Data provided by the National Transportation Safety Board (NTSB). For more information on this event, visit the NTSB Records Search website. NTSB# IAD96LA142