N6861K

Substantial
None

Grumman G-164B S/N: 506B

Accident Details

Date
Wednesday, May 19, 1999
NTSB Number
SEA99LA067
Location
OKANOGAN, WA
Event ID
20001212X18891
Coordinates
48.220611, -119.449722
Aircraft Damage
Substantial
Highest Injury
None
Fatalities
0
Serious Injuries
0
Minor Injuries
0
Uninjured
1
Total Aboard
1

Probable Cause and Findings

A malfunctioning carburetor. Factors include a downdraft, and the soft dirt in a newly plowed field.

Aircraft Information

Registration
N6861K
Make
GRUMMAN
Serial Number
506B
Engine Type
Turbo-shaft
Year Built
1949
Model / ICAO
G-164B G64T
Aircraft Type
Fixed Wing Single Engine
No. of Engines
1

Registered Owner (Historical)

Name
CHRISTIAN ARTHUR DEAN
Address
301 NORTH OSAGE ST
Status
Deregistered
City
GIRARD
State / Zip Code
KS 66743
Country
United States

Analysis

On May 19, 1999, approximately 1145 Pacific daylight time, a Grumman G-164B, N6861K, nosed over in a freshly-plowed field during a forced landing near Okanogan, Washington. The pilot was not injured, but the aircraft, which was owned and operated by Okanogan Air Service, sustained substantial damage. The local 14 CFR Part 137 aerial application flight, which had been airborne for about 30 minutes, was operating in visual meteorological conditions. No flight plan had been filed, and there was no report of an ELT activation.

According to the pilot, while maneuvering over an orchard he was about to spray, the aircraft encountered a "big bump of air" which pulled him up against his seatbelt and shoulder harness. About two seconds later, the engine suddenly lost power, momentarily sputtered, and then quit altogether. The pilot elected to make a forced landing in an Alfalfa field that was straight ahead, so he dumped his remaining chemical and prepared to land. The aircraft initially touched down in the alfalfa, but bounced back into the air and touched down again in a freshly plowed portion of the field. After this second touchdown, the main gear sank into the soft dirt and the aircraft nosed over.

During a post-accident engine run, the engine would not start until the carburetor was tapped several times with a hammer. After jarring the carburetor with the hammer, the engine was able to be started and run. Disassembly of the carburetor did not reveal whether the float had stuck, contamination had temporarily blocked an orifice, or whether there was some other malfunction.

Data Source

Data provided by the National Transportation Safety Board (NTSB). For more information on this event, visit the NTSB Records Search website. NTSB# SEA99LA067