N62793

HISTORY OF FLIGHT

On February 13, 2008, approximately 1255 central standard time, a Piper PA-23-250, N62793, owned and operated by Storm Flying Service, Inc., was destroyed when it impacted terrain 7.5 mile southwest of Sterling, Kansas. Visual meteorological conditions prevailed at the time of the accident. The positioning flight was being conducted under the provisions of Title 14 Code of Federal Regulations Part 91 on an instrument flight rules flight plan. The airline transport certificated pilot was fatally injured. The cross-country flight departed Wichita, Kansas, approximately 1230 and was en route to Hays, Kansas.

According to Storm Flying Service, Inc., of Webster City, Iowa, the flight was repositioning from Wichita to Hays for a daily cancelled check run. The route of flight continued from Hays to Great Bend to Salina to Kansas City and back to Wichita.

At 1249:30, a Kansas City Air Route Traffic Control Center (ARTCC) controller directed the pilot to turn to a heading of 280 to avoid the BISON military operations area (MOA) which was active. The pilot acknowledged this transmission and altered his course accordingly. At 1252:47 the controller called for a radio check and the pilot responded "loud and clear." No further radio transmissions were recorded from the accident airplane.

National Track Analysis Program (NTAP) radar data depicted the airplane on a northwesterly track at 1252:52 at an encoded altitude of 6,000 feet mean sea level (msl) and a groundspeed of 190 knots. At 1253:40 the flight altitude was recorded as 6,100 feet msl and at 1254:28 the altitude was recorded as 6,200 feet msl. The groundspeed slowed to approximately 170 knots. Three primary targets were recorded depicting the airplane in a right turn, with the last target being recorded at 1254:52. No altitude data was associated with these three targets. The last target was recorded 50 feet from the main wreckage.

Several ranchers in the area heard an airplane flying overhead around the time of the accident. One rancher commented that it sounded "choppy like a helicopter." Another commented that he heard a loud rumble, silence, and then a soft rumble. One of the ranchers observed the airplane in flight. He stated that the airplane was "quite a bit lower" than other aircraft that fly in the area. He stated the airplane was straight and level but he did not watch the airplane after that. Shortly thereafter it was reported to them that an airplane had crashed in the field where they kept their cattle.

PERSONNEL INFORMATION

The pilot, age 27, held an airline transport pilot certificate with a multiengine land rating, and a commercial pilot certificate with single-engine land and instrument ratings, last issued on August 14, 2006. In addition, he held a flight instructor certificate with airplane single-engine, multiengine, and instrument airplane ratings. He was issued a second class airman medical certificate on October 12, 2007. The certificate contained the limitation "must wear corrective lenses." At the time of application for medical certification, the pilot estimated a total pilot time of 2,700 hours; 500 hours of which were in the previous six months.

According to the Pilot/Operator Aircraft Accident Report Form submitted by Storm Flying Service, the pilot had logged 3,050 hours total flight time; 1,320 hours of which were in the make and model of the accident airplane and 1,450 hours of which were in multiengine airplanes. They reported that his last flight review and Part 135 check flight took place on September 30, 2007, in a Piper PA-23 with satisfactory results.

A copy of the pilot's personal flight log was provided by the family. The last record of flight was recorded on February 2, 2008, in a Piper PA-23-250 (not the accident airplane). According to the flight log, the pilot had logged no less than 3,011 hours total flight time, 1,265 hours of which were in the make and model of the accident airplane, 340.8 hours in the accident airplane, and 1,411 hours of which were in multiengine airplanes. Neither the flight review nor the Part 135 check flight were recorded in the pilot's personal flight log.

AIRCRAFT INFORMATION

The accident airplane, a Piper PA-23-250 (serial number 27-7754030), was manufactured in 1977. It was registered with the FAA on a standard airworthiness certificate for normal operations. The airplane was powered by two Lycoming IO-540-C4B5 engines rated at 250 horsepower at 2,575 rpm. Each engine was equipped with a 2-blade, controllable pitch, Hartzell propeller.

The airplane was registered to and operated by Storm Flying Service, Inc., and was maintained under a 100 hour/annual inspection program. A review of the maintenance records indicated that a 100 hour inspection had been completed on January 18, 2008, at an airframe total time of 10,852 hours (tach 2,254). The last annual inspection was completed on August 1, 2007, at an airframe total time of 10,653 hours (tach 2,055). The airplane had flown approximately 73 hours between the last inspection and the accident and had an estimated total airframe time of 10,924 hours at the time of the accident. The operator reported that all maintenance was conducted by Hinman Aviation of Webster City, Iowa.

On May 16, 2002, the rod end and bolt on the upper stabilator trim actuator was replaced. According to the director of maintenance at Hinman Aviation, Piper had provided the parts for this replacement, as Piper had received notice of one rod that exhibited corrosion and needed an additional sample from the field for evaluation. No corrosion was noted on the part returned to Piper.

METEOROLOGICAL INFORMATION

The closest official weather observation station was Hutchinson Municipal Airport (HUT), Hutchinson, Kansas, located 26 nautical miles (nm) southeast of the accident site. The elevation of the weather observation station was 1,543 feet msl. The routine aviation weather report (METAR) for HUT, issued at 1252, reported winds, 200 degrees at 14 knots, visibility, 10 miles; sky condition, clear; temperature 12 degrees Celsius (C); dewpoint, minus 02 degrees C; altimeter, 29.87 inches.

WRECKAGE AND IMPACT INFORMATION

The accident site was located in an open, dormant wheat field at an elevation of 1,707 feet msl. Debris extended from the initial impact point, along a magnetic heading of 050 degrees, for 668 feet. The initial impact point was characterized by a long, narrow ground scar with red and white paint chips and small slivers of fiberglass in the southern most point of the ground scar.

Multiple ground scars and debris proceeded for 465 feet from the initial impact point to the main wreckage. A large swath of ground, 35 feet long and 5 feet at its widest point, was discolored and the vegetation exhibited exposure to heat, consistent with a flash fire.

Torn metal, fiberglass insulation, Plexiglass, engine hoses, various engine accessories, portions of the engine cowling, and cabin instruments were located within the debris path. Both ailerons and several wing segments were located throughout the debris field. Several of the wing segments were charred, and partially consumed by fire.

The left stabilator separated from the empennage and was located to the left of the debris field. The underside of the stabilator exhibited aft streaking dark in color, originating from the leading edge rivets. The stabilator was crushed aft and inboard at the outboard tip. The leading edge was partially separated partially along the rivet line and was bent aft.

The right stabilator separated from the empennage and was located adjacent to the main wreckage. The underside of the stabilator exhibited aft streaking dark in color, originating from the leading edge rivets.

The main wreckage, consisting of the fuselage, the vertical stabilizer, rudder, and a portion of the left wing, came to rest 468 feet from the initial impact point. The left wing was inverted and remained partially attached to the fuselage. It exhibited exposure to heat and fire in the area of the fuel tank. The fuselage/empennage came to rest on its left side. The cabin and instrument panel were destroyed. The upper cabin skin was crushed aft and wrinkled.

Cabin instruments displayed the following indications:

Artificial Horizon - Destroyed

Airspeed indicator - 230 knots

Altimeter - needles separated

Kollsman Window - 29.79

HSI - needles separated - heading bug set at 295

Both engine assemblies separated from the airframe and came to rest north of the main wreckage. Examination of both engines revealed normal operational signatures and no anomalies.

A section of the right wing, to include the landing gear assembly, came to rest north of the wreckage. The landing gear was down. The wing separated from the fuselage at the wing root. The aft trailing edge skin, near the wing root, was torn up and outboard. The leading edge skin, in the area inboard of the engine nacelle, was torn aft and crushed. The remaining wing structure, outboard of the engine nacelle, exhibited exposure to heat and fire.

The left side of the aileron follow-up cable separated at the aileron bell crank. The aileron cable on the left side was continuous from the aileron bell crank arm, inboard, to the chain and sprocket assembly. The bell crank arm that attached the left aileron cable separated in signs consistent with overload. The roll bridal cable was frayed at the capstan on the autopilot servo.

The right aileron bell crank separated from the wing and was located within the debris path. Both the aileron and follow-up cables remained attached to the bell crank. The right aileron cable was attached to the chain and sprocket assembly in the nose section. The right side of the aileron balance cable was separated from the left side of the aileron balance cable.

The flap actuator was fully extended. According to Piper this is consistent with the flaps in the fully retracted position.

Both rudder cables remained...