N118SF

MINR
None

Hawker Beechcraft Corp. 99S/N: U-32

Accident Details

Date
Tuesday, February 19, 2008
NTSB Number
CHI08IA085
Location
Moline, IL
Event ID
20080221X00224
Coordinates
41.458889, -90.511947
Aircraft Damage
MINR
Highest Injury
None
Fatalities
0
Serious Injuries
0
Minor Injuries
0
Uninjured
1
Total Aboard
1

Probable Cause and Findings

The arcing of the resistor and silicone controlled rectifier in the flap control circuit.

Aircraft Information

Registration
N118SF
Make
HAWKER BEECHCRAFT CORP.
Serial Number
U-32
Engine Type
Turbo-shaft
Model / ICAO
Aircraft Type
Fixed Wing Multi Engine
No. of Engines
2

Registered Owner (Historical)

Name
BYE UAS INC DBA
Address
8411 FIRESTONE LN NE STE A
Status
Deregistered
City
ALBUQUERQUE
State / Zip Code
NM 87113-1698
Country
United States

Analysis

On February 18, 2008, about 2030 central standard time, a Hawker Beechcraft Corp. 99, N118SF, operated by Suburban Air Freight Inc., as a cargo airplane, received minor damage during cruise when an in-flight fire occurred about 30 miles west of the Quad City International Airport (MLI), near Moline, Illinois. Visual meteorological conditions prevailed at the time of the accident. The unscheduled domestic 14 CFR Part 135 cargo flight had a filed and activated an instrument flight rules flight plan. The pilot was uninjured. The flight originated about 1930 from the Eppley Airfield, near Omaha, Nebraska, and was destined for MLI.

The pilot said that during the descent to MLI he "smelled electrical smoke and saw flames behind the power quadrant." He declared an emergency and removed the fire extinguisher from its holder. In the time it took to do this, the flames were no longer visible and the burning smell was not getting any stronger. The pilot elected to continue to MLI.

A Federal Aviation Administration Inspector examined the airplane. The inspector found that a 10 ohm, 1/2 watt, resistor contacted the ground lug of a silicon controlled rectifier. The components were mounted to a terminal strip located on the aft side of the center pedestal. The components were part of the flap control circuit. The circuit was protected by a five-amp circuit breaker manufactured in 1967. The circuit breaker was checked multiple times to verify what amperage it tripped and the initial test required 17 amps to trip the breaker.

The airplane's last inspection was completed on December 28, 2007. The airplane accumulated 14,079 hours of total time at the time of that inspection.

The manufacturer indicated that manufacturing practice requires electrical wires and leads of resistors and capacitors to be covered with sleeve insulation. The manufacturer indicated that periodic visual inspections of this wire harness per the Model 99 Maintenance Manual should detect sleeve damage that would allow the 10 ohm, 1/2 watt, resistor to contact the ground lug of a silicon controlled rectifier. The 100 hour inspection listed in the Model 99 Airliner Series Maintenance Manual, Chapter 5-20-00, indicated that the instrument plumbing and wiring should be inspected for "condition, attachment, chafing, etc."

Data Source

Data provided by the National Transportation Safety Board (NTSB). For more information on this event, visit the NTSB Records Search website. NTSB# CHI08IA085