N19BB

Substantial
None

BOEING D75N1S/N: 75-3060

Accident Details

Date
Thursday, June 26, 2008
NTSB Number
LAX08LA197
Location
Driggs, ID
Event ID
20080717X01065
Coordinates
43.738887, -111.091941
Aircraft Damage
Substantial
Highest Injury
None
Fatalities
0
Serious Injuries
0
Minor Injuries
0
Uninjured
2
Total Aboard
2

Probable Cause and Findings

The pilot's failure to maintain directional control during landing. Contributing to the accident was wind gusts.

Aircraft Information

Registration
Make
BOEING
Serial Number
75-3060
Engine Type
Reciprocating
Model / ICAO
D75N1B752
Aircraft Type
Fixed Wing Single Engine
No. of Engines
1
Seats
2
FAA Model
A75

Registered Owner (Current)

Name
BOTTOLENE BRIAN J
Address
11729 SPRUCE DR
City
MONTICELLO
State / Zip Code
MN 55362-3502
Country
United States

Analysis

On June 26, 2008, about 1120 mountain daylight time, a Boeing D75N1, N19BB, veered off the runway and nosed over during landing at Driggs-Reed Memorial Airport, Driggs, Idaho. The pilot was operating the airplane under the provisions of 14 Code of Federal Regulations Part 91. The certificated airline transport pilot and passenger were not injured; the airplane sustained substantial damage to the upper left wing. The local flight departed Driggs about 0900. Visual meteorological conditions prevailed, and no flight plan had been filed.

In a written statement, the pilot reported that he performed a wheel landing on runway 21 due to gusty wind conditions. He stated that as the tail settled, a gust of wind caused the airplane to veer to the right and depart the runway. The airplane then encountered a drop-off at the runway edge and nosed over.

A Federal Aviation Administration (FAA) inspector observed a single arcing skid mark on the runway surface that corresponded to the right wheel of the airplane. In addition, recovery personnel reported to the FAA inspector that the wheels of the airplane could not be rotated after the accident, and that the parking brake appeared to be set. The pilot reported that the airplane was not equipped with parking brakes. A local mechanic was called by recovery personnel to assist with moving the airplane after the accident. He stated that when he arrived on scene the airplane was resting on its main landing gear; he checked the main wheels and found that the reason the airplane could not be moved was that one of the wheels was lodged in a divot in the soil. He stated that the wheel was moved out of the divot, and the airplane was then successfully towed back to its hangar.

At a later date, under the auspices of the National Transportation Safety Board investigator-in-charge, the mechanic inspected the brake system. He noted that the wheel assembly was manufactured by Hayes Industries, and was a 27-inch drum and shoe type, number G-3-1. He confirmed that brake pedal travel appeared to be normal, and that wheel rotation would stop when pedal pressure was applied. He confirmed that the airplane was not equipped with a parking brake.

The closest official weather observation station was based at Driggs Airport. An aviation routine weather report (METAR) was issued at 1056. It stated in part: winds from 340 degrees at 7 knots; visibility 10 miles with clear skies. At 1156, the winds were reported as calm. At 1256, the winds were reported from 260 degrees at 15 knots.

A METAR was issued at Jackson Hole Airport, Jackson, Wyoming, which was located 18 miles northwest of the accident site. At 1153, it stated in part: winds from 200 degrees at 14 knots, gusting to 21 knots; visibility 10 miles with clear skies.

The pilot estimated the winds to be variable at 10 knots, gusting to 20 knots.

Data Source

Data provided by the National Transportation Safety Board (NTSB). For more information on this event, visit the NTSB Records Search website. NTSB# LAX08LA197