Summary
On November 03, 2009, a American Aviation AA1 (N7266L) was involved in an accident near Lake Placid, FL. The accident resulted in 1 minor injury, with 1 person uninjured out of 2 aboard. The aircraft sustained substantial damage.
The National Transportation Safety Board determined the probable cause of this accident to be: The pilot's failure to maintain clearance from a power line.
During a local sightseeing flight, the pilot descended through an altitude of 1,000 feet to be able to see a waterway below him. As the pilot performed the low flight maneuver, the airplane impacted a power line, causing the vertical stabilizer to separate from the airplane. The pilot reported experiencing resistance and a vibration with the airplane, followed by a loss of control. He was able to subsequently perform a forced landing straight ahead, during which the airplane sustained damage to the nose gear and to the rudder. A witness stated he heard a low flying airplane, followed by a loud noise similar to a "pop," and then he observed the airplane dragging a cable.
This accident is documented in NTSB report ERA10CA046. AviatorDB cross-references NTSB investigation data with FAA registry records to provide comprehensive safety information for aircraft N7266L.
Accident Details
Probable Cause and Findings
The pilot's failure to maintain clearance from a power line.
Aircraft Information
Registered Owner (Historical)
Analysis
During a local sightseeing flight, the pilot descended through an altitude of 1,000 feet to be able to see a waterway below him. As the pilot performed the low flight maneuver, the airplane impacted a power line, causing the vertical stabilizer to separate from the airplane. The pilot reported experiencing resistance and a vibration with the airplane, followed by a loss of control. He was able to subsequently perform a forced landing straight ahead, during which the airplane sustained damage to the nose gear and to the rudder. A witness stated he heard a low flying airplane, followed by a loud noise similar to a "pop," and then he observed the airplane dragging a cable. Examination of the accident site by a Federal Aviation Administration inspector, revealed the vertical stabilizer, with 150 feet of power line still attached, was located approximately 300 feet aft of the wreckage. No pre-impact malfunctions were reported by the pilot or identified during the post-accident examination.
Data Source
Data provided by the National Transportation Safety Board (NTSB). For more information on this event, visit the NTSB Records Search website. NTSB# ERA10CA046