N925KM

Substantial
None

CESSNA 177BS/N: 17702316

Accident Details

Date
Monday, August 2, 2010
NTSB Number
ERA10LA396
Location
Mashpee, MA
Event ID
20100803X41255
Coordinates
41.549999, -70.483329
Aircraft Damage
Substantial
Highest Injury
None
Fatalities
0
Serious Injuries
0
Minor Injuries
0
Uninjured
2
Total Aboard
2

Probable Cause and Findings

The pilot’s delayed use of carburetor heat while flying at reduced power settings in conditions that were favorable for carburetor icing resulting in the partial loss of engine power.

Aircraft Information

Registration
N925KM
Make
CESSNA
Serial Number
17702316
Engine Type
Reciprocating
Year Built
1975
Model / ICAO
177BC177
Aircraft Type
Fixed Wing Single Engine
No. of Engines
1

Registered Owner (Historical)

Name
ROCKY WINGS INC
Address
779 WASHINGTON ST
Status
Deregistered
City
CANTON
State / Zip Code
MA 02021-3022
Country
United States

Analysis

On August 2, 2010, about 1205 eastern daylight time, a Cessna 177B, N925KM, registered to Rocky Wings, Inc., sustained substantial damage while ditching after a loss of engine power near the southern coastline of Mashpee, Massachusetts. Visual meteorological conditions prevailed and no flight plan was filed for the personal flight conducted under the provisions of 14 Code of Federal Regulations (CFR) Part 91. The private pilot and one passenger were not injured. The flight originated from Fairmouth Airpark, Fairmouth, Massachusetts, about 1000.

The pilot stated that he conducted a thorough preflight inspection and engine run-up before departure, with no discrepancies noted. The flight departed with full fuel tanks and flew locally at 1,000 feet with the power set to 20 inches manifold pressure and 2,300 rpm for most of the flight. While south of Mashpee, preparing to return to the departure airpark, the pilot moved the propeller control to the low pitch position and applied carburetor heat, but the engine lost power. He immediately removed carburetor heat which did not restore engine power, and trimmed to maintain 70 knots while attempting to restore engine power by the application of carburetor heat, and switching the fuel selector to the left and right positions. The engine responded for a few seconds then lost power again. The pilot then concentrated his efforts at flying the airplane and elected to ditch the airplane away from the beach area. The airplane remained upright after water contact and both occupants exited from the co-pilot's door and swam to shore.

Examination of the engine by a Federal Aviation Administration (FAA) airworthiness inspector revealed crankshaft, camshaft, and valve train continuity. Inspection of the ignition system components consisting of the magnetos, spark plugs, and ignition leads revealed no evidence of preaccident failures or malfunctions. Inspection of the air induction and exhaust systems revealed some impact damage but there was no evidence of preaccident failures or malfunctions. Inspection of the oil filter revealed no ferrous contamination, and the fuel system components consisting of the carburetor, engine-driven fuel pump, auxiliary fuel pump and flexible fuel lines revealed no evidence of preaccident failures or malfunctions. No mechanical reasons for the reported loss of engine power could be determined.

Review of FAA Special Airworthiness Information Bulletin CE-09-35, titled Carburetor Icing Prevention revealed that, based on the temperature and dew point about the time of the accident, 75 and 52 degrees Fahrenheit respectively, the atmospheric conditions were favorable for serious icing at glide power.

Data Source

Data provided by the National Transportation Safety Board (NTSB). For more information on this event, visit the NTSB Records Search website. NTSB# ERA10LA396