N402RC

HISTORY OF FLIGHT

On April 10, 2011, about 1815 eastern daylight time, a Cessna 402B, N402RC, was substantially damaged when it impacted a house near Biddeford, Maine. The airline transport certificated pilot was fatally injured. The airplane was registered to My Plane, LLC, and operated under the provisions of 14 Code of Federal Regulation 91 as a positioning flight. Visual meteorological conditions prevailed and no flight plan had been filed. The airplane had departed from West Chester County Airport (HPN), White Plains, New York, about 1630.

The flight originated at Portland International Airport (PWM), Portland, Maine earlier in the day, flew to Nantucket Memorial Airport (ACK), Nantucket, Massachusetts, and acquired 115.6 gallons of 100LL aviation fuel. Then picked up a passenger, flew to HPN, where the passenger disembarked, departed and the pilot was planning to land in PWM. According to Federal Aviation Administration (FAA) Air Traffic Control transcripts, the pilot requested to change his destination to Biddeford Municipal Airport (B19), Biddeford, Maine. Radar data provided by the FAA Portland Air Traffic Control facility, revealed that the airplane overflew the south end of B19 at approximately 1,000 feet above mean sea level (msl), turned left, as if entering the left downwind leg of the airport traffic pattern. Then, approximately 2 miles from the approach end of runway 24, the airplane was observed, on radar, turning right about 250 degrees, and then a slight left turn in the direction of B19. The last radar data was recorded for the accident flight at 1804:29 and was in the vicinity of the accident location. The data indicated an altitude of 400 feet msl and a ground speed of 69 knots.

PERSONNEL INFORMATION

According to FAA records, the pilot, age 71, held an Airline Transport pilot certificate with a rating for airplane multiengine land, commercial pilot privilege for airplane single-engine land, and a certificated flight instructor with ratings for airplane single-engine land, multiengine land, and instrument airplane. His most recent FAA second-class medical certificate was issued February 4, 2011, and at the time of the examination the pilot reported 5,010 total hours of flight experience. According to a resume provided to the pilot's employer in August 2010, the pilot reported 4,735 total hours of civilian flight time as well as military navigator flight time. The resume also indicated 120 flight hours in the accident aircraft make and model. At the time of this writing no pilot logbooks had been located.

AIRCRAFT INFORMATION

According to FAA records, the airplane was manufactured in 1977 and registered to the owner on October 18, 2000. It was equipped with two Continental Motors TSIO-520 series engines. The airplane's most recent annual inspection was dated on August 21, 2010. At the time of the inspection the reported aircraft total time was 6,624.5 time in service and a Hobbs time of 4,554.1 hours. At the time of the inspection the engines had 359.0 hours since overhaul. The most recent maintenance logbook entry was March 21, 2011, and indicated a Hobbs time of 4,567.2 hours. The Hobbs meter was not located in the wreckage.

METEOROLOGICAL INFORMATION

The 1815 recorded weather observation at Sanford Regional Airport (SFM), Sanford, Maine, located approximately 16 miles to the southwest of the accident location, included wind from 150 degrees at 8 knots with gusts of 15 knots, the wind direction was variable from 100 degrees to 160 degrees, visibility 10 miles, clear skies, temperature 14 degrees C, dew point minus 2 degrees C; barometric altimeter 30.03 inches of mercury.

AIRPORT INFORMATION

The airport was equipped with a single runway oriented northeast to southwest and designated as 06/24. The runway was 3000-feet-long and 75-feet-wide, constructed of asphalt, was equipped with a 4-box visual approach slope indicator (VASI) on the left side of runway 6; however, no visual slope indicators were available to runway 24. The airport did not have an air traffic control tower. Communication was accomplished utilizing a common traffic advisory frequency; however, it was not recorded. The airport was served by two approaches to runway 6; however, runway 24 was the preferred calm wind runway.

WRECKAGE AND IMPACT INFORMATION

The airplane impacted four trees varying in diameter from 3.2 inches to 8.75 inches and at a height of approximately 25 feet. The airplane came to rest on the roof of a single story residence that was located approximately 1,491 feet to the northeast of the runway 24 threshold. A post crash fire ensued engulfing the airplane. The left wing was thermally damaged and the outboard section of the wing was located on top of the roof. The left engine was located inside the residence. The right wing and engine were visible above the roof line. The airplane nose section, cabin, and empennage sections were thermally damaged. Portions of all flight controls were located at the accident location.

Examination of the wreckage indicated that the right main landing gear remained attached to the right wing attach point, and was in the down and locked position. The left main and nose gear were separated from the airframe and located within the residence.

The left wing's leading edge exhibited impact damage and the diameter of the damage was similar in dimensions to the diameter of the trees that were initially impacted. The left aileron was consumed by post impact fire. The fuel caps were secured and in place. The fuel tank selector handle located in the cockpit was found in the auxiliary tank position and the fuel valve located in the wing was found between the main and auxiliary tank position. The fuel strainer and filter were thermally damaged and had an area of corrosion in the bottom of the strainer approximately 30 degrees of coverage.

The right wing's aileron was separated and in the vicinity of the right wing. The right wing's outboard section approximately 2 feet inside the main fuel tank, located at the wingtip, was fractured but remained attached to the wing structure. The right main fuel tank was impact damaged near the leading edge of the tank. The right fuel tank selector handle, which was located in the cockpit and the fuel valve located in the wing, were in the main fuel tank position. The fuel strainer was removed from the wing and contained aviation gasoline, the filter was free of debris. The fuel strainer was noted as having an area of corrosion located in the bottom of the strainer and was approximately 30 degrees of coverage and was similar in appearance as the left fuel strainer.

The wing flaps were found in the extended position and were verified by the flap motor chain position located under the cabin floor. Continuity was confirmed from the flap motor to the flap actuator. The right wing flap remained attached to the wing, the left wing flap mechanism remained attached; however, the flap skin was consumed by post impact fire.

The cockpit seats were separated and thermally damaged. Four of the five cabin seat frames remained attached to the cabin floor except for the most aft cabin seat which was located with portions of the flooring still attached to the seat feet.

Rudder continuity was confirmed from the rudder pedals to the rudder horn. The rudder counter weight was located in the wreckage in the vicinity of the empennage. Aileron continuity was confirmed from the cabin chain on the control columns to the aileron sector and then from the aileron sector to both ailerons bell cranks. The aileron sector was impact damaged in the positive direction. The aileron counter weights were located in the vicinity of the associated wing or attached to the wing. Elevator continuity was confirmed from the elevator horn to the swaged end of the cable. The right elevator counter weight remained attached; however, due to thermal damage the left counter weight could not be located.

The stall switch, located in the left wing, was removed and inspected; however, the internal mechanism was damaged and was found in the closed circuit position.

Left Engine

The engine and propeller assembly exhibited impact and thermal damage. The exhaust assembly including the turbocharger, controller, and wastegate assembly were separated from the engine and were located with the main wreckage. The wastegate actuator housing had extensive thermal damage and only the internal components were visible. The cylinders were thermal and impact damaged. The fuel system including the fuel manifold valve, fuel control, and lines had extensive thermal damage. The magnetos and ignition leads had thermal damage. The induction assembly had thermal damage. The induction elbows and air throttle assembly were not found during the inspection. The upper spark plugs were removed and had light gray to dark deposits. The cylinders were boroscoped and the combustion chambers were undamaged. The valves heads were undamaged and had normal thermal discoloration. The oil filler cap had thermal discoloration and damage. No oil was indicated on the engine oil dipstick.

Right Engine

The right engine remained partially attached with impact damage to the left aft mount leg. The engine was removed and the exhaust had impact damage. The exhaust wye-duct was torn and the left section remained attached to the impact damaged wing section. The propeller assembly had impact damage and was removed from the engine. The oil and fuel lines remained attached. The induction assembly was crushed and the No. 6 cylinder riser separated near the cylinder attachment. The fuel manifold valve was undamaged and disassembled. The diaphragm and retaining nut were undamaged and secure. The manifold valve cavity had fuel present and the screen was free of debris. The fuel control was undamaged and the linkages moved freely by hand. The fuel control inlet screen was removed and was free of debris. Approximately 2 ounces of fuel...