Accident Details
Probable Cause and Findings
The pilot in command's failure to follow the normal landing procedures (placing engines into reverse thrust first and then brake), his delayed decision to continue the landing or go-around, and the flight crew's failure to follow emergency procedures once a perceived loss of brakes occurred. Contributing to the seriousness of the passenger's injury was the improper securing of the passenger seat by maintenance personnel.
Aircraft Information
Registered Owner (Historical)
Analysis
HISTORY OF FLIGHT
On October 31, 2011, about 1942 eastern daylight time, a Gulfstream G150, N480JJ, operated by Hendrick Motorsports Aviation, was substantially damaged during a landing overrun at Key West International Airport (EYW), Key West, Florida. The two airline transport pilots and one passenger reported minor injuries, while a second passenger was seriously injured. Night visual meteorological conditions prevailed and an instrument flight rules flight plan was filed for the flight that departed Witham Field Airport (SUA), Stuart, Florida, at 1900. The personal flight was conducted under the provisions of 14 Code of Federal Regulations Part 91.
The pilot-in-command (PIC) stated that air traffic control cleared the flight for a visual approach to runway 27, which was 4,801 feet long. The PIC did not call for the checklist due to radio chatter, but observed the copilot (CP) complete the before landing checks, with the landing gear and flaps extended. The airplane entered the airport traffic pattern on a right base leg for runway 27. The flightcrew lost sight of the runway due to some low stratus clouds and discontinued the approach. The controller then instructed them to overfly the airport and enter a right downwind leg for runway 27, which they did. During the second approach, they again temporarily lost sight of the runway due to clouds, while turning from the base to final leg; however, they were able to visually reacquire the runway on final approach.
The PIC further stated that he continued the approach and touched down about the landing reference speed (Vref) of 120 knots, just past the 1,000-foot touchdown marker on runway 27. The PIC applied brakes and was just about to activate the thrust reversers when he realized the brakes were not working. He stated "no brakes" and the CP also depressed the brake pedals with negative results. The PIC suggested a go-around to the CP, but the CP responded that it was too late. The airplane subsequently traveled off the end of the runway and struck a gravel berm. During the impact, one of the passengers' seat dislodged from its seat track and was found on the cabin floor, with the passenger still in it. The PIC added that maintenance had been performed on the brakes within 10 days of the accident.
The CP's statement was consistent with the PIC's statement. When asked why they did not utilize the emergency brake system, both pilots stated that there was not enough time.
The passenger in the left forward facing seat stated they did not land on the first attempt and the flightcrew did not provide any information. They were in a fairly quick traffic pattern. It was dark with clouds and he could not see very much because the airplane was in a bank and he was concerned about the missed approach. The airplane touched down near the fixed base operator and he did not feel any braking action. This caused more concern because he knew the runway was short. He did not remember hearing the ground spoilers deploy or if the engines spooled up or down. There was no warning from the flightcrew that the airplane was going to depart the runway. He heard someone in the cockpit state, "oh no" right before the airplane departed the runway. There was a big bump, jolt and his seat came out of the seat track and he went forward in the seat. The airplane came to a stop and his wife and the CP came to his assistance and they evacuated the airplane through the cabin door.
PERSONNEL INFORMATION
The PIC, age 47, held an airline transport pilot certificate, with ratings for airplane single-engine land, airplane multiengine land, and instrument airplane, issued on May 6, 2011. He also held a flight instructor certificate, with ratings for airplane single and multiengine, issued on December 22, 2009. His most recent first-class medical certificate was issued on September 6, 2011, with the limitation, "Must have available glasses for near vision." The PIC’s last flight review was conducted in a Gulfstream 500 on October 6, 2011. The PIC estimated that he had about 11,000 total flight hours; of which, 290 hours were in the Gulfstream G150, and about 9,050 hours were in multiengine airplanes. He had about 6,230 hours as PIC; of which, 155 hours were in the G150 and 4,950 hours were in multiengine airplanes. He had flown about 66 hours and 27 hours during the 90 days and 30 days preceding the accident, respectively.
The CP, age 55, held an airline transport pilot certificate, with ratings for airplane single-engine land, airplane multiengine land, and instrument airplane, issued on May 28, 2011. He also held a flight instructor certificate, with ratings for airplane single and multiengine, issued on November 13, 1981. His most recent first-class medical certificate was issued on July 19, 2011, with the limitation, "Must have available glasses for near vision." The CP’s last flight review was conducted in a Gulfstream 500 on April 25, 2011. The CP estimated that he had about 13,500 total flight hours; of which, 75 hours were in the Gulfstream G150, and about 12,300 hours were in multiengine airplanes. He had about 13,000 hours as PIC; of which, 35 hours were in the G150, and 12,000 hours were in multiengine airplanes. He had flown about 75 hours and 7 hours during the 90 days and 30 days preceding the accident, respectively.
Both pilots received training from FlightSafety for normal and abnormal procedures relating to the hydraulic system. The pilots stated in postaccident interviews that they received training on brake failures during landing in the G150, but it was always associated with a hydraulic failure or hydraulic problem in flight. In the simulator, they would follow the procedure in the Quick Reference Handbook and would set the brakes to emergency while in flight. They did not recall training for an unexpected brake failure after landing, which required engaging of the emergency brakes.
AIRCRAFT INFORMATION
The Gulfstream G150, serial number 241, manufactured in 2007, was a nine-place airplane with a retractable tricycle landing gear. It was equipped with two Honeywell TFE731-40AR-2006 engines, each providing 4,420 pounds of thrust. Review of maintenance records revealed that the airplane was maintained under a manufacturer's approved inspection program and its most recent inspection was completed by Gulfstream on December 15, 2010. The airplane had 867.7 hours and 657 cycles at the time of that inspection. The Hobbs meter at the time of the accident was 1,189.8 hours. The airplane had flown 322.1 hours since the last inspection. The transponder, altimeter, encoder, and static system tests were completed on January 5, 2010.
Further review of maintenance records revealed that 4 days prior to the accident, the No. 4 brake swivel was leaking hydraulic fluid. The No. 4 swivel was resealed by a mechanic for the operator in accordance with the Gulfstream G150 maintenance manual. Following the resealing, the brakes were operationally checked. Additionally, the flightcrew did not report any anomalies with braking during their previous landing at SUA.
The airplane was last refueled with 225 gallons of Jet A fuel prior to departure from SUA, on October 31, 2011.
METEOROLOGICAL INFORMATION
The EYW 1953 surface weather observation was: wind 360 degrees at 12 knots, gusting to 17 knots; visibility 10 miles; ceiling broken at 1,000 feet; ceiling broken at 1,400 feet; ceiling broken at 5,000 feet; temperature 26 degrees C; dew point 23 degrees C; altimeter 29.96 inches of mercury.
The PIC stated that he checked the weather several times and had print outs from his preflight weather briefing. He wanted to make sure a line of weather would not affect the flight.
The U. S. Naval Observatory Astronomical Applications department reported the sunset was at 1848 and civil twilight was at 1911. The moon was a waxing crescent with 29 percent of the moon’s visible disk illuminated.
AIRPORT INFORMATION
The EYW airport was owned and operated by Monroe County, Florida. The airport had a single runway and was a 14 CFR Part 139 Class 1, Index B airport. Runway 9/27 was 4,801 feet long, 100 feet wide, and consisted of grooved asphalt in good condition. An engineered material arresting system (EMAS), 340 feet in length and 120 feet in width, was installed at the departure end of runway 9 in October 2010. The safety area at the departure end of runway 27 was extended to 400 feet wide and 600 feet long in May 2011. The safety area at the departure end of runway 27 did not have EMAS installed.
The EYW airport manager stated that due to prevailing wind, 80 percent of the flights land on runway 9 and 20 percent of the flights land on runway 27. There was concern, and a lack of data, for an EMAS at the departure end of runway 27 (approach end of runway 9). Specifically, the concern was that of the 80 percent traffic landing on runway 9, if one airplane were to land short, it would land in an EMAS. There was thought that such an event could be catastrophic; however, there has since been more data of aircraft landing in an EMAS that has not been catastrophic. Subsequently, and after this accident, the airport manager submitted a preapplication with the FAA for an EMAS at the departure end of runway 27.
Four days after the accident with N480JJ, a Cessna 550 airplane, N938D, landed on runway 9 at EYW and was unable to stop prior to overrunning the runway. The airplane entered the EMAS and came to rest about 148 feet into the EMAS. The airplane received minor damage and the two pilots and three passengers were not injured. See NTSB accident number ERA12IA060.
FLIGHT RECORDERS
Cockpit Voice Recorder
The airplane was equipped with a Universal Cockpit Voice Recorder-120 (CVR), serial number 1954. The CVR had not sustained any heat or impact damage and audio information was extracted normally without difficulty. A CVR group was convened at the NTSB Vehicle Recorders Laboratory, Washington, DC, and a pa...
Data Source
Data provided by the National Transportation Safety Board (NTSB). For more information on this event, visit the NTSB Records Search website. NTSB# ERA12FA056