N580TC

HISTORY OF FLIGHT On January 7, 2012, about 1628 Pacific standard time, a Beech 58P, N580TC, was substantially damaged when it landed gear up on runway 19L at John Wayne Airport/Orange County airport (SNA), Santa Ana, California. The owner-pilot and the four passengers were not injured. The personal flight was operated under the provisions of Title 14 Code of Federal Regulations Part 91. Visual meteorological conditions prevailed, and no flight plan was filed for the flight.

According to the pilot, the twin-engine airplane was based at Santa Barbara Municipal Airport (SBA), Santa Barbara, California. The intended destination was SNA, and the pilot planned to overfly Catalina Island en route. The airplane was equipped with one alternator per engine, and an electrical loadmeter and annunciator light for each alternator. When the airplane was in the vicinity of Catalina, the two "ALT" annunciator lights on the instrument panel illuminated, and the loadmeters indicated that the alternators were not providing electrical power to the airplane. The pilot powered off some electrical equipment, and ran his hand across the circuit breaker (CB) panel to ensure all breakers were in; he did not notice any breakers that were out. He then recycled both alternator switches; the ALT lights extinguished, and all other indications returned to normal. The pilot did not know the underlying reason for the problem, and was concerned about the continued availability of electrical power, since nightfall was approaching. He then headed for SNA.

Inbound to the runway at SNA, the pilot selected flaps and landing gear extended, and did not notice anything unusual until he was on short final, when he observed that none of the three landing gear position green annunciation lights were illuminated. He communicated this information to the air traffic control tower controller, and conducted a go-around. He then conducted a flyby of the tower, and asked for the controller's observations regarding the landing gear position. The pilot believed that the controller told him that the landing gear was extended. He therefore did not recycle the gear, and since he was concerned about the possibility of additional problems and approaching darkness, he did not review or execute any abnormal procedures checklists for the landing gear. The pilot was given permission to land, and although he believed the landing gear to be extended, the airplane was landed with the gear fully retracted.

All five occupants exited the airplane uneventfully. After site documentation by airport personnel and the Orange County Sheriff's Department (OCSD), Orange County Fire Department (OCFD) crane and sling equipment was used to lift and relocate the airplane to the county ramp next to Signature Flight Services.

PERSONNEL INFORMATION

According to Federal Aviation Administration (FAA) records, the pilot held a private pilot certificate with multiple ratings, including multi-engine land. The pilot reported a total flight experience of about 972 hours, including about 54 hours multi-engine time, all of which was in the accident airplane make and model. His most recent FAA third-class medical certificate was issued in March 2011.

AIRCRAFT INFORMATION

According to FAA information, the airplane was manufactured in 1977, and was first registered to the pilot in April 2011. The airplane was substantially damaged in a previous landing gear related accident in March 2010 by another pilot. In that accident, the pilot neglected to extend the landing gear prior to landing.

Subsequent to that previous accident, Aircraftsman, a repair facility located at Chino airport (CNO), Chino, California, repaired and sold the airplane to the present owner. The most recent annual inspection was accomplished in conjunction with the repair activity, and was completed in February 2011.

METEOROLOGICAL INFORMATION

The SNA 1647 automated weather observation included winds from 210 degrees at 5 knots, visibility 6 miles, clear skies, temperature 14 degrees C, dew point 9 degrees C, and an altimeter setting of 29.94 inches of mercury.

Local sunset was at 1659, and local civil twilight ended at 1726. Respectively, these were 31 and 58 minutes after the event.

AIRPORT INFORMATION

FAA information indicated that SNA was equipped with two runways, 1R/19L and 1L/19R. Runway 1R/19L measured 2,887 feet by 75 feet, and runway 1L/19R measured 5,701 feet by 150 feet. The airport elevation was 56 feet above mean sea level. At the time of the event, the air traffic control tower was staffed and operational.

WRECKAGE AND IMPACT INFORMATION

The airplane came to rest upright, about halfway down runway 19L. None of the three landing gear was exposed, and all landing gear doors were closed, All evidence was consistent with the landing gear being fully retracted at touchdown.

All three propeller blades on each engine were bent from ground contact. Although not detected until several days after the event, several areas of the fuselage skin and structure were ground away by the skid along the runway, which constituted substantial damage to the airplane.

ADDITIONAL INFORMATION

Post Accident Airplane Activity

Due to the day (Saturday) and lack of severity of the event, FAA personnel did not examine the airplane until Monday January 9. On that day, the FAA inspector observed that the airplane was in the same position and configuration as OCFD had left it; the airplane was on its belly on the county ramp. The inspector noted that the landing gear handle was selected "down," and the landing gear motor was out/popped. Based on the inspector's examination of the airplane (on the ground, as-is), he initially classified the event as an "incident," pending further examination. The inspector then notified the pilot/owner and airport personnel that the airplane was not to be disturbed without NTSB and FAA permission.

Also on Monday January 9, the owner began coordinating with Martin Aviation (located at SNA) to arrange for the raising and re-location of the airplane to the Martin facility (a Beech service center) for detailed examination and repair. In anticipation of that activity, a Martin technician went to photograph the airplane on Monday evening. When he arrived at the airplane, he observed that it had been raised up on jacks. He notified the OCSD about that situation. The next day, the FAA and NTSB were notified that the airplane had been disturbed without their knowledge or approval.

The insurance company representative revealed that he had been contacted by the owner of Aircraftsman, and Aircraftsman told the insurance company that the NTSB had given Aircraftsman permission to begin work on the airplane. This was untrue; the NTSB had not communicated with any representatives of Aircraftsman until after the airplane was observed to be on jacks. The NTSB, FAA, and insurance company agreed that the airplane would be recovered to the Martin ramp by Martin personnel for FAA examination.

On Wednesday January 11, the FAA and Martin Aviation personnel arrived at the airplane on the county ramp and discovered that the airplane was now standing on its landing gear. They also noted leading edge damage to the right wing that was not previously present.

Queries to Aircraftsman revealed that after Aircraftsman had raised the airplane on jacks, the airplane was blown off the jacks by another airplane, which resulted in the wing damage. Aircraftsman personnel then re-raised the airplane, and manually extended the landing gear. None of this activity was authorized by any NTSB, FAA, or insurance company personnel.

After Martin Aviation received written permission to recover the airplane to their facility on the opposite side of SNA, they used the OCFD sling equipment that was used to relocate the airplane to the county ramp after the accident. After relocation to Martin, the gear was confirmed to be locked down, and the airplane was towed into the Martin hangar. It was again jacked up, and the FAA and NTSB were notified of the airplane's location and readiness for further examination

Second FAA Airplane Examination

On January 17, 2012, the FAA inspector re-visited the airplane, and with the Martin technician, accomplished the following activities:

- The landing gear motor CB was re-set

- External battery power was used to retract the landing gear. Retraction function and indications were all normal

- The manual gear extension system was utilized to extend the gear. Extension function and indications were all normal.

- The airplane was equipped with 3 lights which would illuminate green for respective landing gear "down" position; all 3 were observed to illuminate green when the gear was extended

- The gear was again retracted, and the normal extension system was used to re-deploy the gear. Extension function and indications were all normal

Neither the FAA inspector nor the Martin technician observed any landing gear system abnormalities, and both determined that the landing gear extension/retraction system was fully operational.

Additional Pilot Recollections

The pilot provided the following information in response to NTSB and Beech questions regarding the event:

- The pilot observed that both "alternator out" lights on the instrument panel illuminated during the event over Catalina

- He observed a reading of '0' (zero) on the loadmeters when he noticed the electrical problem

- The pilot estimated that he flew "less than 5 minutes" with the alternators off line

- After the pilot reset the alternators, he observed balanced loads on the loadmeters

- He did not have any further alternator or electrical issues for the remainder of the flight (to SNA)

- The pilot heard the landing gear motor activate "for what sounded like the full extension" after he selected landing gear down on his approach to SNA

- The pilot heard the landing gear warning horn "on the go around and the landing"

- When asked by the NTSB...