N8121R

Substantial
None

BEECH 58S/N: TH-690

Accident Details

Date
Tuesday, April 24, 2012
NTSB Number
CEN12LA283
Location
Sioux Falls, SD
Event ID
20120509X23224
Coordinates
43.581943, -96.741943
Aircraft Damage
Substantial
Highest Injury
None
Fatalities
0
Serious Injuries
0
Minor Injuries
0
Uninjured
1
Total Aboard
1

Probable Cause and Findings

The failure of the normal and emergency landing gear system to fully retract or extend the landing gear for reasons that could not be determined during postaccident examinations, which resulted in a partial gear-up landing.

Aircraft Information

Registration
N8121R
Make
BEECH
Serial Number
TH-690
Engine Type
Reciprocating
Year Built
1975
Model / ICAO
Aircraft Type
Fixed Wing Multi Engine
No. of Engines
2

Registered Owner (Historical)

Name
CAWTHORNE KELLY J
Address
100 W MAPLE ST
Status
Deregistered
City
HARRISBURG
State / Zip Code
SD 57032-2111
Country
United States

Analysis

On April 24, 2012, about 1704 central daylight time, a Beech 58, N8121R, experienced a gear-up landing on runway 33 at Joe Foss Field Airport (FSD), Sioux Falls, South Dakota. The pilot was uninjured. The airplane sustained substantial damage to the fuselage. The airplane was registered to and operated by the pilot under the provision of 14 Code of Federal Regulations Part 91. Visual meteorological conditions prevailed at the time of the accident and a flight plan had not been filed for the local flight that departed from the Marv Skie-Lincoln County Airport (Y14), Tea, South Dakota.

The pilot stated that after takeoff from Y14 he was unable to fully retract the landing gear and the landing gear position indicator transition light remained illuminated. He reset the landing gear circuit breaker which was tripped but it tripped again. He tried to extend the landing gear using the manual extension, but the crank arm was stuck. Unable to extend the landing gear, the pilot performed a gear-up landing on runway 33 at FSD, which resulted in substantial damage to the fuselage.

According to an airframe and powerplant mechanic who recovered the airplane, the landing gear was extended to half of its travel. When airplane was raised for recovery, the landing gear retracted into the wheel wells using the airplane electrical system. A Federal Aviation Administration (FAA) inspector stated that during the recovery, the manual landing gear extension handle was difficult to turn.

Postaccident examination of the landing gear system revealed that the landing gear operated normally when actuated about 10 times. There was no obstruction in the landing gear transmission and operation of the landing gear electric motor did not reveal any unusual noises. The stop within the transmission did not provide an over center position, and the landing gear system rods were not deformed. The electric motor had a 1996 date stamp and there was no record that it had been overhauled or repaired.

Data Source

Data provided by the National Transportation Safety Board (NTSB). For more information on this event, visit the NTSB Records Search website. NTSB# CEN12LA283