N6506L

HISTORY OF FLIGHT

On March 31, 2013, at 1250 eastern daylight time, a Lancair LC42-550FG, N6506L, was destroyed when it collided with trees and terrain during a forced landing after a loss of engine power near Smith Reynolds Airport (INT), Winston-Salem, North Carolina. The commercial pilot and pilot-rated passenger were fatally injured. Instrument meteorological conditions prevailed, and an instrument flight rules flight plan was filed for the flight which originated from Wilkes County Airport (UKF), North Wilkesboro, North Carolina, at 1230, and was destined for Warren Field Airport (OCW), Washington, North Carolina. The personal flight was conducted under the provisions of Title 14 Code of Federal Regulations Part 91.

Information from the Federal Aviation Administration (FAA) revealed that the flight departed UKF at 1230 and climbed to 5,000 feet. The flight was in cruise flight about 5,000 feet when at 12:46.34, the pilot declared an emergency and reported a "low fuel pressure – engine's quitting." The air traffic controller vectored the airplane toward INT, and during the descent the pilot reported smoke in the cockpit and subsequently reported that the engine was "barely" producing power. At last report, the airplane was about 6 miles from INT, and no further transmissions were received from the pilot.

In an email, one witness stated that he heard the airplane, but could not see it due to low, irregular clouds. He said the airplane was "making a slightly uneven noise – like a sputter but more like its power was changing erratically." The witness further stated that the sound of the engine didn't not fade gradually as he expected, but "went abruptly silent." He later learned that the airplane crashed about six miles from the spot where he heard the sounds overhead.

Another witness reported to police that he saw the airplane flying just above the trees. He stated that the airplane was not trailing smoke, and that the propeller was not rotating. A third witness said the airplane was flying close to the tops of the trees, and the engine was sputtering as though it "may have run out of gas." A fourth witness reported seeing a "large blue object" just above the fence in her back yard before it exploded and burst into flames. She stated she heard no noise and didn't discover the object was an airplane until later.

PERSONNEL INFORMATION

The pilot held a commercial pilot certificate with ratings for airplane single-engine land and instrument airplane. Her most recent FAA third-class medical certificate was issued on December 2, 2011, and she reported 800 total hours of flight experience on that date. An examination of the pilot's logbook revealed about 963 total hours of flight experience, 291 hours of which were in the accident airplane make and model.

The pilot-rated passenger held a private pilot certificate with ratings for airplane single-engine land and instrument airplane. His most recent third-class medical certificate was issued on November 19, 2010 and he reported 300 total hours of flight experience on that date. Examination of the pilot-rated passenger's logbook revealed that it was severely damage by fire and water. The total hours of flight experience, and time in make and model could not be determined, however it's estimated that the total hours of flight experience were about 460 hours. The last entries in the logbook appeared to be in December 2012 based on entries in previous pages.

AIRCRAFT INFORMATION

The airplane was manufactured in 2003, and was a pre-molded, composite built, semi-monocoque, four-seat, single engine, low wing, tricycle design airplane. The airplane was certified in the utility category and was used primarily for transportation and general aviation uses. The airplane was equipped with a Continental IO-550N, 310-horsepower engine. Examination of FAA records and copies of maintenance receipts revealed its most recent annual inspection was completed July 26, 2012 at 1,088 aircraft hours.

Subsequent to the annual inspection, the airplane underwent service and maintenance on five occasions. The work included an oil change, alternator change (2), and a starter adapter change. Each time an engine run was performed and a leak check was noted. The most recent maintenance run and leak check was annotated February 11, 2013.

Engine oil history

A review of the maintenance records revealed that the previous owner of the airplane had engine oil leaks corrected during 2009 and 2010. The repairs to and replacement of pushrod tubes, rocker covers, sump gaskets, and a front crankshaft seal were noted. Further, the Nos. 1, 2, and 5 cylinders were replaced on September 28, 2010.

On July 25, 2012, during the owner's pre-purchase inspection of the airplane, the left magneto oil seal was replaced due to "leaking." No further engine oil leaks were noted in the airplane's maintenance records.

METEOROLOGICAL INFORMATION

At 1254, the weather conditions reported at INT, at 969 feet elevation and 4 miles east of the accident site, included an overcast ceiling at 800 feet, visibility 7 miles, temperature 13 degrees C, dew point 11 degrees C, and an altimeter setting of 29.89 inches of mercury. The winds were from 240 degrees at 7 knots.

WRECKAGE AND IMPACT INFORMATION

The accident site was located on flat, wooded terrain in a residential area approximately 3 miles west of INT, and all major components of the airplane were accounted for at the scene. The wreckage path was oriented approximately 078 degrees magnetic and about 400 feet in length. The initial impact point was in a tree top; about 50 feet above the ground, and fragments of the airplane were distributed along the wreckage path.

The cockpit, cabin area, and engine compartment were consumed by postcrash fire. The main wreckage rested on its left side, and had been cut and displaced by first responders. Control continuity could not be determined due to significant fire damage, but flight control components that were examined exhibited fractures consistent with overload failure.

The engine remained in its mounts, attached to the fuselage, and each of the three propeller blades exhibited aft bending and spanwise scratching. The engine was severely damaged by fire and impact. The engine oil sump was completely burned away, and the engine case exhibited holes from both internal and external impact. Due to the extent of the damage, and the hazard of burned composite materials, no examination of the engine was conducted on site. The engine was retained for a detailed examination at a later date.

No evidence of oil streaking or staining of the airframe could be identified, as the airframe surrounding and aft of the engine compartment was completely destroyed by fire. The tail section was separated from the airplane, and displayed impact and postcrash fire damage. The exterior surfaces were stained from soot consistent with the postcrash fire.

MEDICAL AND PATHOLOGICAL INFORMATION

The Wake Forest University School of Medicine, Department of Pathology performed the autopsies on the pilot and the pilot-rated passenger. The autopsy report indicated that each died as a result of "multiple injuries."

The FAA's Bioaeronautical Sciences Research Laboratory, Oklahoma City, Oklahoma, performed toxicological testing of the pilot. The testing was negative for drugs, alcohol, and carbon monoxide.

TESTS AND RESEARCH

The engine was examined in Mobile, Alabama at the manufacturer's facility under the supervision of an NTSB senior air safety investigator. The engine exhibited significant impact and thermal damage, and the crankcase was breached above the Nos. 4, 5, and 6 cylinders. Disassembly revealed connecting rod, bearing cap, piston skirt, and hardware fragments in the oil sump. These fragments could not be matched with their associated engine components.

The Nos. 1 and 2 connecting rod assemblies were intact, but displayed thermal discoloration. Their respective connecting rod bearings exhibited lubrication distress and thermal smearing of the surface babbit, exposing the copper layer.

The Nos. 3, 4, 5 and 6 connecting rods were separated from the crankshaft. The No. 6 connecting rod separated from the crankcase and was not recovered.

The airplane was equipped with Avidyne Multi-Function Display (MFD) and Primary Flight Display (PFD), as well as analog engine instruments on the left side of the instrument panel, and analog flight instruments between the PFD and MFD in the center of the panel.

The MFD unit displayed the pilot checklist, terrain/map information, approach chart information and other aircraft/operational information depending on the specific configuration and options installed. One of the options available was comprehensive engine monitoring and performance data.

The PFD unit included a solid state Air Data and Attitude Heading Reference System (ADAHRS) and displayed aircraft flight data including altitude, airspeed, attitude, vertical speed, and heading. The PFD unit had external pitot and static port inputs for altitude, airspeed, and vertical speed information. Each PFD contained two TSOP2 Flash memory devices mounted on a riser card. The flash memory stored information the PFD unit used to generate the various PFD displays. Additionally, the PFD had a data logging function which is used by the manufacturer for maintenance and diagnostics.

The MFD and PFD were examined in the NTSB Vehicle Recorders Laboratory on November 1, 2013. Both displays exhibited major fire damage, and disassembly revealed major fire damage to the compact flash (CF) cards as well. The memory flash chips were removed, re-soldered to their respective CF cards, and placed in an Avidyne test bench equipped with a surrogate MFD and PFD.

The data was downloaded from each CF card, both engine and flight parameters were graphed, and a Google Earth overlay of the flight path was plotted. Engine parameters graphed included engine rpm, exhaust gas te...