N22MS

HISTORY OF FLIGHTOn May 13, 2013, about 1245 Pacific daylight time, a Gates Learjet 35A, N22MS, overran the runway during landing at McMinnville Municipal Airport, McMinnville, Oregon. The airplane was registered to Evergreen Equity, Inc., and operated by Evergreen International Aviation, Inc., under the provisions of 14 Code of Federal Regulations Part 91, as a post-maintenance positioning flight. The airline transport pilot, commercial rated copilot, and company mechanic/passenger were not injured. The airplane sustained substantial damage during the accident sequence. The cross-country flight departed Grand Junction Regional Airport, Grand Junction, Colorado, about 1145 mountain daylight time, with a planned destination of McMinnville. Visual meteorological conditions prevailed at McMinnville, and an instrument flight rules flight plan had been filed.

The NTSB investigator traveled in support of this investigation, and performed an examination of the airframe subsequent to recovery.

The pilot reported that prior to departure he had been briefed by the mechanic who was to fly with them, that all preflight inspections had been completed. The pilot and the copilot then performed a pre-start checklist, which he described as extensive because the airplane had just come out of maintenance. All systems were normal, including the brakes and nose wheel steering.

The pilot reported that the flight and landing approach were uneventful, and as the airplane touched down about 500 feet beyond the approach end of runway 22 he deployed the spoilers, and then pulled the thrust levers to the idle/deploy detent position. The DEPLOY lights did not illuminate, so he recycled the thrust levers back into the detent, but again the reversers did not deploy. With about 2,000 feet remaining on the marked runway and at a speed of about 25 knots, he applied pressure to the foot pedal brakes, but did not feel a response, even though the brake pressure gauge indicated normal pressure. The copilot also attempted, but reported that the pedals felt loose, and the airplane did not slow down.

The pilot stated that as the airplane approached the runway end, the copilot pulled the thrust levers past the deploy detent; the engine speed increased and the airplane began to accelerate. He warned the copilot, concerned that this action was increasing forward thrust, and he moved the levers back to the Idle/Deploy detent. The pilot then engaged the STEER LOCK switch, and attempted to steer the airplane left with the nose wheel, but the airplane did not respond. Just prior to reaching the end of the stopway, he activated the emergency braking lever; however, the airplane rolled off the stopway, through a set of instrument landing system antennas, and down an embankment.

The pilot stated that this was his first experience using the emergency brake system in a Lear 35, and that he did not feel the need to use them during the later stages of the ground roll because it appeared the airplane was coming to a stop by itself. He was concerned that activating them earlier or more aggressively would cause the brakes to lock, leaving minimum control with the inoperative steering. PERSONNEL INFORMATIONThe pilot held an airline transport pilot certificate with ratings for airplane multiengine land including commercial privileges for airplane single-engine land. He held type ratings for the B-727, B-747, DC-8, G-IV, and LR-JET, as well as a flight instructor certificate for airplane single- and multiengine land, and instrument airplane. He reported a total flight time in all aircraft of 17,563.2 hours, with 996.9 in the accident make and model. He had flown the accident make and model 17.2 hours in the previous 90 days, and 2.2 hours in the last 30 days. He held a first-class medical certificate, with limitations that he wears corrective lenses.

The copilot held an airline transport pilot certificate with ratings for airplane multiengine land including private privileges for airplane single-engine land. He held type ratings for the DHC-8 (second in command privileges). He reported a total flight time in all aircraft of 2,553 hours, with 94 in the accident make and model. He had flown the accident make and model 17 hours in the previous 90 days, and 4 hours in the last 30 days. He held a first-class medical certificate, with no waivers or limitations. METEOROLOGICAL INFORMATIONAn automated surface weather observation was issued at McMinnville airport at 1153. It indicated wind from 220 degrees at 7 knots, visibility 10 miles, with scattered clouds at 2,600 feet, broken at 3,100, and an overcast ceiling at 5,500 feet, temperature 17 degrees C, dew point 12 degrees C, with an altimeter setting at 30.08 inches of mercury. WRECKAGE AND IMPACT INFORMATIONThe airplane came to rest within a bramble patch down an embankment just beyond the instrument landing system antennas at the departure end of runway 22. The fuselage remained intact, and sustained damage to the nose landing gear, which had folded aft. The belly skin just aft of the nose landing gear door was punctured, with corresponding damage to the belly stringers. Both wings exhibited multiple indentations to their leading edges, crushing them back to the forward spar. Examination of a series of rivets around the cabin area revealed dislocation consistent with deformation of the airplanes primary structure.

Although tire marks were present in the soft mud beyond the runway, no corresponding skid marks were noted along the runway surface. FLIGHT RECORDERSThe airplane was equipped with a Universal CVR-30 cockpit voice recorder. The unit did not sustain any damage, and was sent to the NTSB Vehicle Recorder Division's Audio Laboratory for audio extraction and content summary. The unit had recorded the last 30 minutes of the flight on two separate channels, which included the intercom system and the cockpit area microphone (CAM).

The recording essentially supported the pilot and copilot statements, and began with the airplane at flight level 280, with the pilot flying as pilot-in-command. Over the next 27 minutes, the crew communicated with air traffic control, initiated an uneventful descent, and completed checklists in a challenge/response fashion. The pilot asked for flaps 8, and the copilot acknowledged, as air traffic control personnel advised them to switch to the McMinnville advisory frequency. The flight progressed with the landing checks, and the landing gear was heard to extend. The landing checks were completed during the descent. A short time later there were three audible clicks recorded by the CAM, followed by a sound of "bump-bump," similar to touchdown.

Four seconds later, the pilot reported that the thrust reversers had not come out. The copilot asked if the control was all the way back, and a click was heard followed by a decrease in engine noise. The engine noise then increased, and the pilot stated, "no. they're sure not workin". A click and snap sound was then heard, and the pilot stated, "I can hear 'em though". The copilot stated that he had taken off his headphones to try and listen for the reversers. The engine noise again decreased, and the pilot stated he would try the thrust reverser's again. Thirty seconds had now passed since touchdown, and the engine sound again began to increase. The pilot then stated that they were not working, and the copilot exclaimed, "you got it?" to which the pilot replied in the affirmative, and the copilot said, "slow'er down". Over the next 10 seconds, they continued to exchange words regarding slowing down and exiting the runway. The pilot then stated, "oh, emergency" and the sound of three snaps were heard followed by an increase in engine noise. A few seconds later, the pilot stated, "emergency brake...okay" and the engine noise began to decrease. Over the next 8 seconds the crew expressed concern that they could not stop before the end of the runway, and then a thump sound was heard similar to impact. For the next 33 seconds until the end of the recording, sounds similar to an engine shutdown and crew-egress were recorded.

The total time from the sound of the landing gear making contact with the runway, to the sound of the presumed impact, was 63 seconds. TESTS AND RESEARCHA complete report of the airplane systems examination is contained within the public docket.

Squat Switches

The airplane, by design, was equipped with a redundant series of squat switches located on the left and right main landing gear strut torque arms. The switches were positioned to activate when the landing gear was extended, and the airplane was on the ground. The switches were connected within the electrical system, and configured to prevent inadvertent activation of core airplane systems during various modes of flight. The design was such that when the airplane was on the ground, the following occurred:

- A circuit was broken, which prevented the airplane from landing with the brakes applied.

- A circuit was completed, which energized the squat switch relay panel, in turn disabling the nose wheel steering system, and preventing deployment of the thrust reversers.

Post-accident examination of both the left and right landing gear struts revealed that each of their squat switch assemblies were partially detached from their upper scissor arm fork pads. On both sides, all three switch attachment screws were loose, with the switches rising between 1/8 and 1/4 inches from the pads. The switch roller bearing surfaces were not making positive contact with their respective scissor arm cams, thereby deactivating the switches. Under these circumstances, the airplane systems would interpret that the airplane was in air-mode, when it was in fact on the ground.

The switches were removed, and their mounting screws and pad surfaces were examined. All the bolt threads were sharp, with no flattening damage noted to the thread crests. The scissor pad and squat assembly mating surfaces we...