N5196W

HISTORY OF FLIGHTOn February 19, 2015, about 1835 Atlantic standard time, an experimental, amateur-built Rans S-6ES Coyote II, N5196W, ditched in the waters of the Mona Passage after a partial loss of engine power near Rincon, Puerto Rico. The private pilot sustained minor injuries, and the passenger was fatally injured. The airplane sustained substantial damage. Visual meteorological conditions prevailed, and no flight plan was filed for the local personal flight operated under the provisions of 14 Code of Federal Regulations Part 91, which departed Eugenio Maria de Hostos Airport (TJMZ), Mayaguez, Puerto Rico, about 1815.

According to the pilot, he arrived at TJMZ on the day of the accident about 1600 to purchase the airplane. After a short test flight of about 15 to 20 minutes, he paid the owner for the airplane. He then received a telephone call from his brother-in-law and invited him to come out to the airport for a short flight to show him the airplane he had just purchased. The pilot left the airport about 1802, purchased premium automobile gasoline for the airplane at a local gas station, and refueled the airplane. After the refueling process was complete, about 1815, he and his brother-in-law (the passenger) boarded the airplane and taxied out for takeoff. The pilot verified that the gasoline valve was on and conducted a magneto check. After takeoff, they climbed to about 1,000 ft above sea level.

About 20 minutes into the flight, the pilot noticed that the engine was not producing enough power to sustain flight. The engine never lost power completely, but it would not produce full power, so he began to troubleshoot while he flew a course that would place the airplane parallel to the shoreline over shallow water near Rincon. He saw that there were people and sharp rocks along the shoreline, so he decided not to land on the beach but to ditch the airplane in the water. He maneuvered the airplane until it was 4 to 6 ft above the water, set the wing flaps to 20°, stalled the airplane, and touched down on the surface of the water. Upon touchdown, the airplane decelerated and sank but did not nose over. The pilot released his seatbelt and, about 5 seconds later, was able to egress and swim to the surface.

When the pilot reached the surface, he did not see his passenger. He swam back down to the wreckage, released the passenger's seatbelt and swam him up to the surface, but the passenger was not breathing. By this time, a person on a boogie board had reached them. They placed the passenger on the boogie board and paddled him to the beach. Cardio pulmonary resuscitation was performed but was unsuccessful. PERSONNEL INFORMATIONThe pilot held a Federal Aviation Administration (FAA) private pilot certificate with a rating for airplane single-engine land. His most recent FAA third-class medical certificate was issued on September 8, 2014. He reported that he had accrued about 609 total flight hours. AIRCRAFT INFORMATIONThe airplane was a kit-built, two-seat, high-wing, airplane. The cockpit was constructed of welded 4130 steel tubing, and the rear fuselage was constructed of bolted aluminum tubing. The wings and tail surfaces were covered in presewn Dacron envelopes. The airplane was equipped with tricycle-type landing gear.

The airplane was assembled from a kit by the original owner and issued an FAA special airworthiness certificate on April 18, 1994. At the time of issuance, the airplane was powered by a Volkswagen air-cooled engine, driving a composite, ground-adjustable IVO propeller. Shortly thereafter, the Volkswagen engine was replaced with a Rotax 582 engine that had been manufactured in November 1990.

On March 5, 2006, in Cartersville, Georgia, the airplane was involved in an accident (NTSB Case No. ATL06LA048) during an instructional flight. The NTSB determined that the probable cause of the accident was: "The loss of engine power during cruise flight for undetermined reasons, which resulted in a forced landing, on ground collision with a ditch, and nose over."

On March 7, 2006, the airplane was sold by the original owner, and over the next 2 years, the airplane was owned by a succession of individuals in the continental US. On March 8, 2008, the engine was replaced with another Rotax 582 engine. Later that year, the airplane was shipped to Puerto Rico.

On April 20, 2009, a liquid-cooled, 64-horsepower, Rotax 582 Mod 99 engine, with dual carburetors and dual ignition, driving a three-blade, Warp Drive, ground-adjustable propeller was installed. Over the next 5 years, the airplane was once again owned by a succession of owners, until March 5, 2014, when it was sold to the previous owner, who operated it for about 11 months and sold it to the pilot on the day of the accident.

The airplane's most recent condition inspection was completed on November 26, 2014. At the time of the inspection, the airplane had accrued 881.5 total hours of operation, and the engine had accrued 191.5 total hours of operation. METEOROLOGICAL INFORMATIONAt 1750, the reported weather at Rafael Hernandez Airport (TJBQ), Aguadilla, Puerto Rico, located 11 nautical miles northeast of the accident site, included: wind 310° at 9 knots, 7 miles visibility in light rain, scattered clouds at 1,000 ft, broken clouds at 2,100 ft, overcast clouds at 5,000 ft, temperature 23°C, dew point 22C, and an altimeter setting of 29.99 inches of mercury. AIRPORT INFORMATIONThe airplane was a kit-built, two-seat, high-wing, airplane. The cockpit was constructed of welded 4130 steel tubing, and the rear fuselage was constructed of bolted aluminum tubing. The wings and tail surfaces were covered in presewn Dacron envelopes. The airplane was equipped with tricycle-type landing gear.

The airplane was assembled from a kit by the original owner and issued an FAA special airworthiness certificate on April 18, 1994. At the time of issuance, the airplane was powered by a Volkswagen air-cooled engine, driving a composite, ground-adjustable IVO propeller. Shortly thereafter, the Volkswagen engine was replaced with a Rotax 582 engine that had been manufactured in November 1990.

On March 5, 2006, in Cartersville, Georgia, the airplane was involved in an accident (NTSB Case No. ATL06LA048) during an instructional flight. The NTSB determined that the probable cause of the accident was: "The loss of engine power during cruise flight for undetermined reasons, which resulted in a forced landing, on ground collision with a ditch, and nose over."

On March 7, 2006, the airplane was sold by the original owner, and over the next 2 years, the airplane was owned by a succession of individuals in the continental US. On March 8, 2008, the engine was replaced with another Rotax 582 engine. Later that year, the airplane was shipped to Puerto Rico.

On April 20, 2009, a liquid-cooled, 64-horsepower, Rotax 582 Mod 99 engine, with dual carburetors and dual ignition, driving a three-blade, Warp Drive, ground-adjustable propeller was installed. Over the next 5 years, the airplane was once again owned by a succession of owners, until March 5, 2014, when it was sold to the previous owner, who operated it for about 11 months and sold it to the pilot on the day of the accident.

The airplane's most recent condition inspection was completed on November 26, 2014. At the time of the inspection, the airplane had accrued 881.5 total hours of operation, and the engine had accrued 191.5 total hours of operation. WRECKAGE AND IMPACT INFORMATIONOn February 21, 2015, the wreckage of the airplane was recovered from about 20 ft of water about 200 ft off the beach near Rincon and transported to the Port of Mayaguez.

Examination of the airplane and engine revealed that the firewall and engine mounts were bent and broken, and the engine had been removed during the recovery. Both carburetors were displaced from their mounting positions, the coolant lines had been cut, and all spark plugs had sustained impact damage. The propeller was still attached to the engine gearbox, and all three propeller blades remained attached to the propeller hub. Surface corrosion could be seen on all exposed aluminum parts of the airplane, which was consistent with the airplane's submergence in sea water.

Engine

Examination of the intake system revealed that the air filters were the proper type but had suffered damage from impact or recovery of the wreckage from the ocean, and the element pleats were packed with dirt and sand.

Examination of the exhaust system revealed that a large section of the exhaust system was missing. Only the exhaust "Y" pipe, the first portion of exhaust system which connected both cylinders to a single section of exhaust pipe and held the two exhaust gas metering probes, was still attached to the engine.

Examination of the spark plugs and dual capacity discharge ignition system revealed that the spark plugs were impact damaged, had non-conforming removable resistor caps, and had rust-colored water droplets on them, which was indicative of sea water being present in the combustion chambers. The ignition modules were of the proper type and in good physical condition. The ignition wires also of the proper type and had incurred impact damage.

Examination of the coolant system revealed that the overflow bottle was missing; all the coolant hoses were breached; the water pump was intact; and the coolant radiator was still attached to the firewall but was heavily damaged. There was no evidence of coolant remaining in the system.

Examination of the injection oil lubrication system revealed that it had been disconnected and was no longer operational. This required the pilot to premix the fuel with oil at a 50:1 ratio before pouring it into the airplane's fuel tanks.

Examination of the rotary lubrication system revealed that the system and the oil tank were contaminated with sea water, and the perpendicular shaft and rotary valve plate were corroded due to submersion.

An attempt to rotate th...