N3718X

Substantial
None

AERO COMMANDER 100 180S/N: 5022

Accident Details

Date
Tuesday, June 14, 2016
NTSB Number
CEN16LA249
Location
Port Lavaca, TX
Event ID
20160706X42954
Coordinates
28.659721, -96.435279
Aircraft Damage
Substantial
Highest Injury
None
Fatalities
0
Serious Injuries
0
Minor Injuries
0
Uninjured
1
Total Aboard
1

Probable Cause and Findings

Loss of engine power due to failure of a connecting rod. 

Aircraft Information

Registration
Make
AERO COMMANDER
Serial Number
5022
Engine Type
Reciprocating
Year Built
1968
Model / ICAO
100 180VO10
Aircraft Type
Fixed Wing Single Engine
No. of Engines
1
Seats
4
FAA Model
100-180

Registered Owner (Current)

Name
MILLER PAUL DOUGLAS
Address
421 E GEORGE ST
City
PORT LAVACA
State / Zip Code
TX 77979-3046
Country
United States

Analysis

On June 14, 2016, about 0945 central daylight time, an Aero Commander model 100-180 airplane, N3718X, was substantially damage during a forced landing following a loss of engine power near Port Lavaca, Texas. The pilot was not injured. The airplane was registered to and operated by the pilot under the provisions of Title 14 Code of Federal Regulations Part 91 as a personal flight. The pilot reported that he felt a vibration and heard a "bang" about 15 minutes after takeoff when the airplane was at 1,100 ft above ground level. The engine subsequently began to lose power. The oil pressure dropped to zero as the pilot heard another "bang" and then the propeller stopped turning. He executed a forced landing to a pasture, and the nose landing gear collapsed due to the soft ground.

A postaccident airplane examination revealed that the engine mount was damaged. An engine examination determined that the No. 4 connecting rod had separated from the crankshaft. The connecting rod mating flanges common to the rod cap were fractured. A fragment of the bearing was partially extruded around the connecting rod. The rod cap was deformed. A mating portion of one connecting rod flange remained secured to the rod cap by the attachment bolt and nut. The opposite connecting rod flange was fragmented and deformed. The attachment bolt was fractured. The bolt shank exhibited necking adjacent to the fracture surface; the mating portion of the bolt and the nut were not recovered. Three bearing fragments were recovered; each fragment was deformed and appeared worn. All fracture surfaces sustained secondary mechanical damage which precluded further examination.

A review of the airplane maintenance records by a Federal Aviation Administration inspector revealed that the most recent engine overhaul was accomplished about 25 years before the accident flight. The engine manufacturer recommended that all engine models be overhauled within 12 years of the "date they first entered service or of last overhaul" in order to "mitigate engine deterioration that occurs with age." However, an aircraft owner is not required comply with the engine manufacturer's recommended overhaul interval when operating under Part 91 unless the engine does not meet the requirements of an annual inspection.

Data Source

Data provided by the National Transportation Safety Board (NTSB). For more information on this event, visit the NTSB Records Search website. NTSB# CEN16LA249