N3803J

HISTORY OF FLIGHTOn February 23, 2017, about 1300 mountain standard time, a Beechcraft A36TC airplane, N3803J, was substantially damaged when it impacted terrain shortly after takeoff from Stevensville Airport (32S), Stevensville, Montana. The private pilot and his passenger received minor injuries. The airplane was registered to Big Sky Specialized Carriers and operated by the pilot as a Title 14 Code of Federal Regulations Part 91 personal flight. Visual meteorological conditions prevailed at the time of the accident and no flight plan was filed. The cross-country flight was originating at the time of the accident.

According to the pilot, he based the airplane at 32S. The takeoff was conducted from runway 12. Before takeoff, the pilot noted that the windsock indicated a straight cross wind with gusts coming from both directions. The pilot confirmed manifold pressure and fuel consumption as he held the brakes. The pilot then "accelerated" the airplane to "80" [knots] and then lifted off. Shortly after, the airplane "couldn't climb or accelerate." The pilot stated that he was unaware of the cause of the problem, and that it felt like there was a "rapid decrease in power." He reported that he ensured that the engine controls were in their appropriate positions for full takeoff power, but that the airplane "would not lift" any further. The pilot reported that he had insufficient time to scan the engine power instruments or diagnose the problem, due to the airplane's proximity to the ground. The pilot did not retract the landing gear during the event. He did not report his maximum altitude, but he did report that he had previously experienced problems with the turbocharger system.

Ground scars indicated that the airplane struck terrain about 300 ft to the right side of runway centerline and traveled a few hundred ft after initial ground contact. The airplane came to rest upright.

A pilot-rated eyewitness who was situated on the northeast side of the runway, about 2,400 ft from the runway 12 threshold, reported that his attention was called to the airplane by its engine sound. He reported that the engine sounded normal, which he elaborated as both "strong and loud" and "ear piercing loud." The airplane just broke ground as it passed abeam of him, and he then mentioned to a person who was with him to watch the airplane, because its takeoff appeared to be unusual. The airplane achieved a maximum altitude of about 50 ft above the ground, and then began a "steep right descending turn." The right wingtip struck the ground first; it exhibited a brief flash of fire which quickly extinguished. The witness stated that runway 12 has a "substantial" uphill slope, and the terrain and trees also rise in that direction. He also reported that at the time, there was a "quartering tailwind" from the "northwest" of about 15 knots. PERSONNEL INFORMATIONThe pilot held a private pilot certificate with a single-engine airplane land rating, which was issued in June 2015. According to information provided by the pilot, he had 569 total hours of flight experience, including about 162 hours in the accident airplane make and model. His most recent Federal Aviation Administration (FAA) third-class medical certificate was issued in April 2015. AIRCRAFT INFORMATIONThe single-engine airplane was manufactured in 1980, and was equipped with a Continental TSIO-520 series engine. The pilot purchased the airplane in February 2016.

The airplane was equipped with Genesis Aero wingtip fuel tanks, via Supplemental Type Certificate (STC) SA2460CH. These tanks enabled the carriage of 40 gallons total of additional fuel and were installed in June 2008. The STC also provided for a maximum takeoff weight increase from the original value of 3,650 lbs to the new value of 3,833 lbs.

A review of the maintenance records indicated that the most recent annual inspection was completed on September 24, 2016. The corresponding airframe logbook entry did not indicate an airframe total time (TT) in service but did note a tachometer time of 2,859.0 hours. The most recent airframe entry was dated February 1, 2017, and indicated a tachometer time of 2,920.9 hours. That entry also indicated a TT of the same value.

The engine logbook indicated that in August 2010, the engine was "major overhauled to manufacturer's specifications." At that time the engine had a TT of 2,282.1 hours. The engine logbook indicated that as part of the September 2016 annual, all six cylinders were removed and replaced with "new Continental Loaded Cylinders." The most recent engine logbook entry, for an oil change, was dated February 17, 2017. That entry cited an airframe TT of 2,920.9 hours, and a time since major overhaul of 633.7 hours.

The propeller logbook indicated that the airplane was equipped with a Hartzell Model PHC-C3YF-1RF propeller, which was in accordance with the A36TC type certificate data sheet. The 3-blade propeller was overhauled in September 2005, when it had a TT of 1,877.8 hours, and the governor was overhauled at the same time as the 2010 engine overhaul.

At the time of the accident, the tachometer registered about 2,927 hours. METEOROLOGICAL INFORMATIONThe airport's sole windsock, which the pilot stated he referenced during his taxi-out, was situated about 400 ft northeast the runway centerline, and about 1,500 ft along the runway 12 axis. The windsock was about 100 ft west-southwest of a hangar. It was mounted on a pole about 20 ft high. The taxi route from the pilot's hangar to the runway ran adjacent to this windsock.

According to the airport manager, a DigiWx brand automated weather observation system (AWOS) was installed at 32S in November 2016. The system sensed and recorded multiple parameters, including wind direction, steady state speed and gusts, and temperature, on a one-minute interval basis. At the time of the accident, due to its recent installation, the system had not been assigned its own discrete broadcast radio frequency for pilots to obtain the weather observations. Instead, the information was broadcast on the airport's CTAF frequency; pilots could prompt a broadcast by a series of 5 microphone clicks on the CTAF frequency. The pilot never clarified whether he obtained the AWOS broadcast.

The wind speed and direction sensor for the AWOS system was located near the approach end of runway 12. The sensor was about 300 ft northeast of the runway centerline, and about 100 ft along the runway 12 axis. The sensor was mounted on a mast about 10 ft high, on moderately flat, open terrain, with no nearby obstructions.

The AWOS data for the period of the accident from 1256 to 1303, recorded the wind from 340° and 350° magnetic, between 9 and 12 knots, with numerous gusts to 16 kts. The averaged values were 347° at 11 kts, with 16 kt gusts. The observations also reported visibility 10 miles, temperature 2° C, dew point -6° C, and an altimeter setting of 29.98 inches of mercury (In Hg).

The above values resulted in the following computed values for a departure from runway 12:

- Wind component (steady state): - 8.5 kts (tailwind)

- Wind component (gust): - 11.2 kts (tailwind)

- Station Pressure: 26.27 In Hg

- Pressure altitude: 3,556 ft

- Density altitude: 2,914 ft AIRPORT INFORMATIONThe single-engine airplane was manufactured in 1980, and was equipped with a Continental TSIO-520 series engine. The pilot purchased the airplane in February 2016.

The airplane was equipped with Genesis Aero wingtip fuel tanks, via Supplemental Type Certificate (STC) SA2460CH. These tanks enabled the carriage of 40 gallons total of additional fuel and were installed in June 2008. The STC also provided for a maximum takeoff weight increase from the original value of 3,650 lbs to the new value of 3,833 lbs.

A review of the maintenance records indicated that the most recent annual inspection was completed on September 24, 2016. The corresponding airframe logbook entry did not indicate an airframe total time (TT) in service but did note a tachometer time of 2,859.0 hours. The most recent airframe entry was dated February 1, 2017, and indicated a tachometer time of 2,920.9 hours. That entry also indicated a TT of the same value.

The engine logbook indicated that in August 2010, the engine was "major overhauled to manufacturer's specifications." At that time the engine had a TT of 2,282.1 hours. The engine logbook indicated that as part of the September 2016 annual, all six cylinders were removed and replaced with "new Continental Loaded Cylinders." The most recent engine logbook entry, for an oil change, was dated February 17, 2017. That entry cited an airframe TT of 2,920.9 hours, and a time since major overhaul of 633.7 hours.

The propeller logbook indicated that the airplane was equipped with a Hartzell Model PHC-C3YF-1RF propeller, which was in accordance with the A36TC type certificate data sheet. The 3-blade propeller was overhauled in September 2005, when it had a TT of 1,877.8 hours, and the governor was overhauled at the same time as the 2010 engine overhaul.

At the time of the accident, the tachometer registered about 2,927 hours. WRECKAGE AND IMPACT INFORMATIONThe engine mount was partially separated from the firewall, and the cowling and propeller were significantly damaged. The fuselage exhibited some crush, twist, and wrinkling deformation, but retained the cabin occupiable volume.

The wings and the tail aerodynamic surfaces all remained attached to the fuselage. The flaps were observed to be in the fully retracted position. Both wingtip fuel tanks were fractured, and the left wing leading edge incurred crush damage. The nose and left main landing gear were completely fracture-separated from the airplane. The right main landing gear was partially separated from the airplane. There was no fire.

The front seats remained attached to their mounts, and the occupant restraint belts remained intact. The aft, club-seating arrangement cabin was reported to be "full" o...