N60E

HISTORY OF FLIGHTOn June 25, 2018, about 0815 eastern daylight time, a Cessna 340A airplane, N60E, overran the runway during an aborted takeoff at Orlando Executive Airport (ORL), Orlando, Florida. The private pilot and 3 passengers were not injured. The airplane was substantially damaged when it encountered a drainage culvert after it exited the paved runway surface. The airplane was registered to Little Dreams Aviation, and operated as a Title 14 Code of Federal Regulations Part 91 personal flight. Visual meteorological conditions existed at ORL about the time of the accident. The flight was originating from ORL when the accident occurred.

According to the pilot the airplane remained unhangared at ORL for about a week before the accident. On the day of the accident the engine start, run-up, and taxi were all normal. The pilot began the takeoff roll using the full length of runway 7. He reported that at first, the takeoff roll and acceleration seemed normal, but then he felt a "sudden lag in…forward motion." The pilot stated that the maximum speed he observed on the airspeed indicator (ASI) was 43 knots, and that the ASI needle "seemed to be fluttering" at that speed, and was no longer indicating an increase in speed. Those observations prompted the pilot to verify that the mixture, propeller, and throttle controls were fully forward, which they were. The pilot did not observe or report any explicit engine problems or asymmetric power. However, based on the "lag" sensation and the ASI indications, the pilot decided to discontinue the takeoff.

The pilot said that he began the abort procedure when the airplane was about half-way down the runway, and that he "pulled power'" and used the brakes and spoilers to decelerate the airplane. He determined that the airplane did not appear likely to stop before overrunning the end of the runway, and in order to avoid a collision with antennae and lights beyond the runway end, he steered the airplane off the right side of the end of the runway. The airplane tracked though grass for a distance, and then struck and stopped in a drainage culvert that was oriented parallel to the runway. The pilot shut down the airplane and the occupants exited. PERSONNEL INFORMATIONFederal Aviation Administration (FAA) records indicated that the pilot held a private pilot certificate with airplane singe-engine land, multi-engine land, and instrument airplane ratings. The pilot reported that he had a total flight experience of about 1,078 hours, including about 396 hours in multi-engine aircraft, and about 33 hours in the accident airplane make and model. His most recent flight review was completed in May 2018, and his most recent FAA third-class medical certificate was also issued in May 2018. AIRCRAFT INFORMATIONThe airplane was manufactured in 1979, and was equipped with two Continental Motors TSIO-520 series engines. The airplane was registered to the pilot on March 27, 2018. The pilot reported that the airplane had a total time (TT) in service of about 4,518 hours. The left engine had a TT of about 2,642 hours, and a time since major overhaul (TSMOH) of about 385 hours. The right engine had a TT and TSMOH of about 1,043 hours. The airplane's most recent annual inspection was completed in October 2017.

In 1998 the airplane was modified by RAM Aircraft Corporation to install multipleengine, propeller, and airframe modifications intended to improve overall airplane performance. In addition, the modification package provided an increase in the airplane maximum allowable takeoff weight from the Cessna value of 5,990 lbs to the RAM value of 6,390 lbs. Airplane documentation indicated that RAM included a modified "Operations Manual" and a "Supplemental Flight Manual" to reflect the operational and performance changes.

The airplane was equipped with a single pitot tube, which was mounted on the lower portion of the fuselage nose. Two static ports, one per side, were mounted on the fuselage nose. The pilot reported that he had covered the pitot tube during the week the airplane was in ORL, but that he did not, and normally did not, cover the static ports. He reported that during his preflight inspection, he removed the pitot cover, inspected all three articles, and did not detect any anomalies.

The airplane was equipped with a total of three airspeed indication displays. Two, one each per left and right side instrument panel, were the standard 3" diameter mechanical-pneumatic analog devices. The third display was a digital value presented on the Garmin Primary Flight Display (PFD) that was installed on the left side instrument panel. METEOROLOGICAL INFORMATIONThe 0753 ORL automated weather observation included winds from 070° at 4 knots, visibility 10 miles, clear skies, temperature 26° C, dew point 24° C, and an altimeter setting of 30.11 inches of mercury. AIRPORT INFORMATIONThe airplane was manufactured in 1979, and was equipped with two Continental Motors TSIO-520 series engines. The airplane was registered to the pilot on March 27, 2018. The pilot reported that the airplane had a total time (TT) in service of about 4,518 hours. The left engine had a TT of about 2,642 hours, and a time since major overhaul (TSMOH) of about 385 hours. The right engine had a TT and TSMOH of about 1,043 hours. The airplane's most recent annual inspection was completed in October 2017.

In 1998 the airplane was modified by RAM Aircraft Corporation to install multipleengine, propeller, and airframe modifications intended to improve overall airplane performance. In addition, the modification package provided an increase in the airplane maximum allowable takeoff weight from the Cessna value of 5,990 lbs to the RAM value of 6,390 lbs. Airplane documentation indicated that RAM included a modified "Operations Manual" and a "Supplemental Flight Manual" to reflect the operational and performance changes.

The airplane was equipped with a single pitot tube, which was mounted on the lower portion of the fuselage nose. Two static ports, one per side, were mounted on the fuselage nose. The pilot reported that he had covered the pitot tube during the week the airplane was in ORL, but that he did not, and normally did not, cover the static ports. He reported that during his preflight inspection, he removed the pitot cover, inspected all three articles, and did not detect any anomalies.

The airplane was equipped with a total of three airspeed indication displays. Two, one each per left and right side instrument panel, were the standard 3" diameter mechanical-pneumatic analog devices. The third display was a digital value presented on the Garmin Primary Flight Display (PFD) that was installed on the left side instrument panel. WRECKAGE AND IMPACT INFORMATIONTire tracks in the grass indicated that the airplane exited the southeast corner of the paved surface of runway 7. The airplane came to a stop upright, partially in the drainage culvert, with a significant nose down pitch attitude. The stopping point was about 500 ft beyond the runway pavement end, and offset about 300 ft from the runway centerline. The stopping point was located about 6,500 ft from where the airplane began its takeoff roll. The nose and nose landing gear were substantially damaged, and the right side propeller was also damaged.

The engines remained attached to the airframe. One propeller blade on the right engine was bent aft at midspan of the blade. The top and side cowlings were removed from both engines. No anomalies were visually observed. The top spark plugs were removed, and the electrodes exhibited normal worn out signatures compared to the Champion Check a Plug chart.

The crankshafts were rotated manually using the propellers. Sparks were observed on all top ignition leads, and thumb compressions were obtained on all cylinders. Visual inspections of the cylinder combustion chambers via lighted borescope did not reveal any anomalies.

A test of the airplane airspeed indicating system, minus the pitot tube, was conducted. A test unit was coupled to the pitot input line just downstream of where the pitot tube had been connected. The test unit provided known pressure inputs corresponding to known airspeeds, in 20 kt increments from 20 to 100 kts inclusive, and then two more stepped inputs of 150 and 200 kts. The airspeed values were displayed on the Garmin PFD and two other mechanical ASIs mounted on the instrument panel. All three ASI values corresponded to the test pressure/speed values throughout the entire speed range of the test, and no leaks were detected in the system. ADDITIONAL INFORMATIONWeight and Balance

The pilot provided the following values as the basis for his airplane weight calculations:

Airplane empty weight = 4,700.71 lbs

Combined front seat pilot and passenger weight = 321.5 lbs

Combined aft seat passenger weight = 276 lbs

Baggage weight = 152.76 lbs.

Ramp fuel weight = 966 lbs

Takeoff fuel weight = 936 lbs

The pilot provided both maximum allowable and calculated ramp and takeoff weights for the flight. According to the pilot, the maximum allowable ramp weight was 6,430 lbs, and his calculated ramp weight was 6,417 lbs. The maximum allowable takeoff weight was 6,390 lbs. The pilot allowed a start/taxi fuel value of 30 lbs (5 gallons), which resulted in his calculated takeoff weight of 6,387 lbs. The pilot's calculations indicated that the airplane was loaded within the allowable CG range.

None of the pilot's airplane, payload, or fuel weight values were able to be independently verified by the investigation.

Airplane Performance

The airplane manufacturer (Cessna) provided separate takeoff distance charts for the 'accelerate-go' and the 'accelerate-stop' cases. These charts presented data for a maximum airplane weight of 5,990 lbs. Although the airplane documentation indicated that RAM provided modified Operations Manual and a Supplemental Flight Manual, the pilot did not provide those documents to the investigation.

...