Accident Details
Probable Cause and Findings
The airplane's inability to climb due to reduced engine power as a result of insufficient compression in all cylinders and fouled spark plugs in the No. 2 cylinder while operating near its maximum gross weight.
Aircraft Information
Registered Owner (Historical)
Analysis
***This report was modified on September 3, 2020. Please see the docket for this accident to view the original report.***
On July 28, 2018, about 1225 central daylight time, a Piper PA-28-140 airplane, N624FL, was substantially damaged when it was involved in an accident near Columbia, Illinois. The pilot and two passengers were seriously injured, and one passenger sustained minor injuries. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 as a personal flight.
According to information obtained by the responding Federal Aviation Administration (FAA) inspector, the airplane departed runway 3 at Sackman Field (H49) and was en route to Alton, Illinois. Witnesses told the FAA they observed the airplane depart the airport and climb at a shallower than normal attitude. The airplane appeared to level off as it continued away from the airport until it contacted transmission lines about 1/2 mile from the departure end of the runway.
The FAA inspectors postaccident examination of the airframe did not find any anomalies which would have precluded normal operation. An examination of the engine conducted by the FAA inspector found fouled sparkplugs in cylinder No. 2 and a compression check of all the cylinders found low compression on each. (The No. 1 cylinder compression was 50 psi, the No. 2 cylinder compression was 19 psi, the No. 3 cylinder compression was 52 psi, and the No. 4 cylinder compression was 50 psi.) A borescope and visual inspection of the No. 2 cylinder did not detect the reason for its low compression.
Lycoming Service Instruction 1191A states that "if the pressure reading for all cylinders is equal and above 70 psi; the engine is satisfactory; less then 65 psi indicates wear has occurred and subsequent compression checks should be made at 100 hour intervals to determine rate and amount of wear. If the pressure reading is below 60 psi …, removal and overhaul of the cylinders should be considered." The instruction also states that low pressure in a single cylinder is indicative of air passing by the piston or valve.
In addition, the FAA inspector performed a weight and balance calculation with the occupants' weights obtained by first responders and verified by the pilot. The calculation revealed that the airplane was near the airplane's maximum gross weight.
Data Source
Data provided by the National Transportation Safety Board (NTSB). For more information on this event, visit the NTSB Records Search website. NTSB# CEN18LA299