N773CB

HISTORY OF FLIGHTOn August 24, 2018, about 1235 eastern daylight time, a Beech A36, N773CB, was substantially damaged when it was involved in an accident near Quincy Municipal Airport (29J), Quincy, Florida. The private pilot was seriously injured. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 personal flight.

The pilot stated that the purpose of the flight was to fly the airplane to Jefferson Landings Airport (74FL), Monticello, Florida for its annual inspection, which was overdue. He performed a walk-around inspection of the airplane using the checklist, and stated that "everything was good." The inspection included a check of each fuel tank for contaminants, none were found. After starting the engine, he performed a run-up, which included a check of the magnetos and cycling of the propeller, noting that the magneto checks produced "hardly any [rpm] drop at all."

The pilot further stated that he taxied a considerable distance to the runway with the auxiliary fuel pump off, indicating that the engine-driven fuel pump was operating satisfactorily. He initiated takeoff with the fuel selector positioned to what he recalled was the left tank. During the initial climb, the engine suddenly lost total power. The pilot did not recall if the propeller stopped. He immediately pitched to maintain airspeed and performed a forced landing, during which the airplane impacted a tree.

A witness noticed the accident airplane when it was halfway down runway 14 during the takeoff roll. He observed the airplane lift off and start to climb. When the airplane got above tree-top level, he noticed that the landing gear was still down, the nose pitched up slightly, and the airplane stopped climbing. The airplane continued to pitch up and began rolling to the left. The left bank and nose-high attitude continued as the airplane began losing altitude; he then lost sight of the airplane behind trees.

Another witness reported that he saw the airplane in the initial climb after takeoff at a very shallow angle, in a nose-high attitude, still at full power. The airplane then turned to the left while seeming to slow. The left wing was down at an approximate 40° to 45° angle. The airplane seemed like it was buffeting, but the engine was still at full power. He could see the entire roof, both wings and both horizontal stabilizers. The airplane then disappeared behind the trees, and he heard the impact.

AIRCRAFT INFORMATIONThe airplane was originally equipped with a 300-horsepower Continental Motors, Inc., IO-550-B engine, which was modified in May 2002, in accordance with (IAW) supplemental type certificate (STC) SE5222NM by "turbonormalizing" and installing a turbocharger and associated equipment. It was also modified by installation of a constant-speed MT propeller IAW STC SA02535CH.

According to the Flight Manual Supplement (FMS) associated with the engine modification, the fuel flow range for takeoff was 32.0 to 35.0 gallons per hour (gph), and the FMS specified the fuel pump to be on the "lo" position during takeoff. A note indicated that if the fuel flow exceeded the red line limit, to manually lean to fuel flow red line prior to takeoff.

GPS data was correlated with data downloaded from the engine monitor, which recorded every 6 seconds. The fuel flow increased to 31 gph, consistent with application of takeoff power, then 6 seconds later, the fuel flow was 38 gph. The fuel flow dropped to 37 gph and remained at that value for 6 seconds, until the airplane was past the departure end of runway 14 at 332 ft GPS altitude (about 125 ft above runway elevation) and 80 knots groundspeed, the fuel flow was recorded as 12 gph. At that moment, the exhaust gas temperature, cylinder head temperature, and rpm readings peaked from the previous values. The fuel flow then increased to about 16 gph, decreased to about 10 gph, then increased to about 14 gph. During that time, to the end of the GPS-recorded data, the airplane continued climbing, attaining a maximum GPS altitude of 347 ft and slowed to 64 knots groundspeed. The accident site was located about 630 ft east of the last GPS data point.

The pilot stated that the airplane was last refueled at 2J9 either in April or May 2018. He reported that the wings and tip tanks were filled at that time, but he may have flown the airplane on a short trip after fueling, which would have resulted in between 80 and 100 gallons of fuel onboard at the time of takeoff.

According to data downloaded from the GPS, the last two flights were on April 14th, and April 15th, 2018.

AIRPORT INFORMATIONThe airplane was originally equipped with a 300-horsepower Continental Motors, Inc., IO-550-B engine, which was modified in May 2002, in accordance with (IAW) supplemental type certificate (STC) SE5222NM by "turbonormalizing" and installing a turbocharger and associated equipment. It was also modified by installation of a constant-speed MT propeller IAW STC SA02535CH.

According to the Flight Manual Supplement (FMS) associated with the engine modification, the fuel flow range for takeoff was 32.0 to 35.0 gallons per hour (gph), and the FMS specified the fuel pump to be on the "lo" position during takeoff. A note indicated that if the fuel flow exceeded the red line limit, to manually lean to fuel flow red line prior to takeoff.

GPS data was correlated with data downloaded from the engine monitor, which recorded every 6 seconds. The fuel flow increased to 31 gph, consistent with application of takeoff power, then 6 seconds later, the fuel flow was 38 gph. The fuel flow dropped to 37 gph and remained at that value for 6 seconds, until the airplane was past the departure end of runway 14 at 332 ft GPS altitude (about 125 ft above runway elevation) and 80 knots groundspeed, the fuel flow was recorded as 12 gph. At that moment, the exhaust gas temperature, cylinder head temperature, and rpm readings peaked from the previous values. The fuel flow then increased to about 16 gph, decreased to about 10 gph, then increased to about 14 gph. During that time, to the end of the GPS-recorded data, the airplane continued climbing, attaining a maximum GPS altitude of 347 ft and slowed to 64 knots groundspeed. The accident site was located about 630 ft east of the last GPS data point.

The pilot stated that the airplane was last refueled at 2J9 either in April or May 2018. He reported that the wings and tip tanks were filled at that time, but he may have flown the airplane on a short trip after fueling, which would have resulted in between 80 and 100 gallons of fuel onboard at the time of takeoff.

According to data downloaded from the GPS, the last two flights were on April 14th, and April 15th, 2018.

WRECKAGE AND IMPACT INFORMATIONThe airplane came to rest inverted adjacent to trees in the front yard of a residence, about 1/4 mile east-southeast of 2J9. Recovery personnel reported that the left fuel tank was intact and contained an estimated 20 to 25 gallons of fuel, while the right fuel tank was breached. The Federal Aviation Administration (FAA) inspector who examined the wreckage at the accident site took a photograph of the cockpit, which depicted the fuel selector positioned to the right main fuel tank. He also reported that fires were started when the recovery crew attempted to cut the right wing off, which the fire department extinguished. The fire department then used battery-powered tools to cut the wings off due to the fuel at the scene.

Examination of the airplane following recovery revealed the landing gear was extended and the flaps were retracted.

Four ounces of light purple-colored liquid was drained from the right wing fuel tank sump drain. The sample did not smell of fuel, and was tested using water finding paste, which detected water. Only drops of blue-colored liquid consistent with 100 low lead aviation fuel were drained from the fuel strainer. Both wing fuel tank strainer screens were free of obstructions, though the left was crushed/deformed. The fuel strainer screen was removed, and the screen element was clean, but the "cone" portion contained trapped debris. No obstructions were noted from each wing root through the fuel selector valve, auxiliary fuel pump, to the engine-driven fuel pump inlet for the left and right fuel selector positions. No fuel was noted in the inlet or outlet lines at the auxiliary fuel pump, nor at the flexible fuel hoses at the engine-driven fuel pump. The engine-driven fuel pump was removed from the engine and the drive coupling was intact. The fuel pump operated smoothly when rotated manually and no fuel was expelled. The throttle body fuel screen was removed and inspected. No contamination was discovered and only a very small drop of fuel was expelled when the fuel screen was removed.

Examination of the left wing fuel vent system revealed the inboard scoop assembly and extended vents were not located or observed. No obstructions were noted from the outer flange vent into the tank or to the wing root area where the vent line was crushed. The check valve was installed in the proper orientation and was free of obstructions.

Examination of the right wing fuel vent system revealed tan-colored debris completely blocked the opening of the inboard scoop assembly vent. Following removal of the debris, the line was blocked at an unknown location along its length. The inboard extended vent was free of obstructions from the opening to where the vent line was cut for recovery at wing station 71. The outer flange-vent was clear from the lower wing surface to the aluminum line that was fractured. The check valve that was recovered was matched with the fractured aluminum line and was installed in the correct orientation. The "T-fitting" that would have been installed inboard of the check valve was not located. No obstructions were noted from the remainder of the vent line into the fuel tank. The vent line inboard of the fuel tank was fragmented, and/or could not ...