Accident Details
Probable Cause and Findings
The pilot's decision to perform a touch-and-go landing at a high-density altitude airport, with a tailwind, and on an upsloping runway, which resulted in decreased airplane performance and the airplane’s inability to become airborne within the available runway.
Aircraft Information
Registered Owner (Current)
Analysis
On November 20, 2018, about 0930 mountain standard time, a Cessna 172 airplane, N27LA, was substantially damaged when it was involved in an accident near Colorado Springs, Colorado. The commercial pilot and passenger sustained minor injuries. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 personal flight.
The pilot reported that, after departure, they flew to a different airport and conducted three uneventful touch-and-go landings. He then proceeded to the accident airport and performed a straight-in approach to runway 33. He approached the runway at a normal speed of 60 knots with the flaps fully down and the "mixture set appropriately for the 7,000-ft field elevation"; he did not apply carburetor heat. The airplane landed, and he added full power, raised the flaps, and raised the nose to take off. The airplane became airborne about 50 knots but did not accelerate; instead, the airspeed decreased to about 45 knots. The airplane began exhibiting characteristics consistent with a stall, and he lowered the nose. The airplane settled back onto the ground slightly off the left side of the runway surface and rolled through a grassy field, a fence, and impacted a ditch. The airplane nosed over and came to rest inverted.
Witnesses reported observing the airplane in a nose-high attitude before it descended from view. Shortly thereafter, they observed people running toward the airplane.
Examination conducted by a Federal Aviation Administration (FAA) inspector revealed that the flaps were fully extended. The flap indicator in the cockpit displayed 40°.
Weather about the time of the accident was reported as wind from 130° at 4 knots, temperature 9°C, dewpoint -11°C, and an altimeter setting of 30.26 inches of mercury, which corresponded to a density altitude of about 7,386 ft. According to the FAA Airport/Facility Directory, "runway 15 is recommended for takeoff, touch and go landings when effective tailwind is less than 5 knots". The directory stated that runway 33 had an upslope of 1.4%. Runway 15/33 was 60 ft wide and about 6,000 ft long.
The takeoff performance chart in the 172M Pilot Operating Handbook indicates the following airplane configuration and environmental conditions during takeoff: Flaps up; full throttle prior to brake release; zero wind; and a paved, level, dry runway. The notes section stated, "for operation with tailwinds up to 10 knots, increase distances by 10% for each 2 knots." It further stated, "prior to takeoff from fields above 3,000 feet elevation, the mixture should be leaned to give maximum RPM in a full throttle, static runup."
Data Source
Data provided by the National Transportation Safety Board (NTSB). For more information on this event, visit the NTSB Records Search website. NTSB# WPR19TA034