N26498

Substantial
None

Robinson R22S/N: 0836

Accident Details

Date
Friday, June 28, 2019
NTSB Number
CEN19LA187
Location
Danbury, TX
Event ID
20190628X74925
Coordinates
29.232778, -95.251945
Aircraft Damage
Substantial
Highest Injury
None
Fatalities
0
Serious Injuries
0
Minor Injuries
0
Uninjured
1
Total Aboard
1

Probable Cause and Findings

A failed electrical relay, which provided an improper indication of a governor and clutch problem, which resulted in the pilot conducting a precautionary landing during which he failed to maintain sufficient main rotor speed.

Aircraft Information

Registration
Make
ROBINSON
Serial Number
0836
Engine Type
Reciprocating
Year Built
1988
Model / ICAO
R22R22
Aircraft Type
Rotorcraft
No. of Engines
1
Seats
2
FAA Model
R22 BETA

Registered Owner (Current)

Name
DODSON INTERNATIONAL PARTS INC
Address
2155 VERMONT RD
City
RANTOUL
State / Zip Code
KS 66079-9014
Country
United States

Analysis

On June 28, 2019 at 1132 Central Daylight Time, a Robinson R-22 Beta helicopter, N26498, impacted terrainnear Danbury, Texas. The commercial pilot was not injured. The helicopter was substantially damaged. The helicopter was registered to a corporation and operated as a 14 Code of Federal Regulations Part 137 pollination flight. Visual meteorological conditions were reported at the accident site and along the route of flight about the time of the accident.

The pilot reported to the FAA he was conducting pollination activities when the "clutch" light illuminated and would not go out and he began to loose power, so he "set it down" in the field. He pilot told the mechanic selected to repair the helicopter that he was flying low over the agricultural field when the "GOV" (governor) caution light illuminated, followed by the "clutch light" illuminating. He felt the helicopter began to lose rotor speed and responded by rolling the engine power. He landed the helicopter vertically and did not split the skids; however, the main rotor speed decayed sufficiently enough that a main rotor blade drooped and struck the tail cone, substantially damaging the helicopter.

The mechanic reported that during an examination of the helicopter the "actuator" engaged and disengaged normally, the drive belts were in good condition, and the clutch rotated normally. The governor light remained illuminated regardless of the switch position. He traced the light to a faulty electrical relay that caused the light to illuminate, and stated the faulty relay would only cause the light to come on and would not affect the governor operation. He verified the governor operated normally when electrical power was applied. No other anomalies were found with the helicopter.

Data Source

Data provided by the National Transportation Safety Board (NTSB). For more information on this event, visit the NTSB Records Search website. NTSB# CEN19LA187