N569JC

Substantial
None

Vans VANS RV-10S/N: 40569

Accident Details

Date
Saturday, September 21, 2019
NTSB Number
CEN19LA326
Location
Lancaster, TX
Event ID
20190923X91342
Coordinates
32.577499, -96.717498
Aircraft Damage
Substantial
Highest Injury
None
Fatalities
0
Serious Injuries
0
Minor Injuries
0
Uninjured
4
Total Aboard
4

Probable Cause and Findings

A partial loss of engine power due to a faulty magneto/ignition system, which resulting in a forced landing.

Aircraft Information

Registration
N569JC
Make
VANS
Serial Number
40569
Model / ICAO
VANS RV-10

Analysis

On September 20, 2019, about 1940 central daylight time, an experimental, amateur-built RV-10 airplane, N569JC, sustained substantial damage when it was involved in an accident near Lancaster, Texas. The airline transport pilot and three passengers were not injured. The airplane was operated as a Title 14 Federal Code of Regulations Part 91 personal flight.

The pilot reported that the 40-minute flight was uneventful until he conducted a touch-and-go landing. During the initial climb, the nosewheel sounded like it was vibrating, and the engine backfired and lost partial power. The pilot decided that he could not land on the remaining runway, so he climbed the airplane, raised the flaps, and increased airspeed to 95 to 100 knots. The manifold pressure was dropping from 17 to 14” with full throttle and the engine power continued to decrease.

The pilot decided to try a gentle turn toward the airport before realizing that he did not have adequate altitude, and instead conducted a forced landing to a field, during which the nose landing gear and main landing gear collapsed. Both wings sustained substantial damage. All occupants exited the airplane. The airplane was recovered to a secure facility for examination.

Teardown examination of the engine did not reveal any mechanical anomalies. The fuel system was intact, and no obstructions or leaks were observed. The magnetos were bench tested. The right magneto displayed no anomalies. The left magneto fired on 3 of the 6 terminals.

The airplane was equipped with a G3i electronic ignition system that was coupled to the magnetos. The system created multiple sparks over a longer duration and synchronized timing between the two magnetos. This synchronization was accomplished by using the left magneto as a trigger for the complete system. While the electronic ignition was operating, it relied solely on the left magneto points to fire left and right magnetos with an enhanced multi-spark. If the left magneto failed or deteriorated, then the complete ignition cycle would be compromised.

Data Source

Data provided by the National Transportation Safety Board (NTSB). For more information on this event, visit the NTSB Records Search website. NTSB# CEN19LA326