N5197Y

Substantial
None

Air Tractor AT 602S/N: 602-0529

Accident Details

Date
Tuesday, February 25, 2020
NTSB Number
CEN20LA109
Location
Dumas, AR
Event ID
20200225X74134
Coordinates
33.869998, -91.526947
Aircraft Damage
Substantial
Highest Injury
None
Fatalities
0
Serious Injuries
0
Minor Injuries
0
Uninjured
1
Total Aboard
1

Probable Cause and Findings

The pilot’s failure to maintain clearance from a power line pole during a low-level aerial application flight, which resulted in impact with the bracket and a subsequent forced landing.

Aircraft Information

Registration
N5197Y
Make
AIR TRACTOR
Serial Number
602-0529
Engine Type
Turbo-shaft
Year Built
1999
Model / ICAO
AT 602AT6T
Aircraft Type
Fixed Wing Single Engine
No. of Engines
1

Registered Owner (Historical)

Name
SALE REPORTED
Address
10043 HINTERLAND DR
Status
Deregistered
City
PELKIE
State / Zip Code
MI 49958
Country
United States

Analysis

On February 25, 2020, about 1030 central standard time, an Air Tractor AT-602, N5197Y, was substantially damaged when it was involved in an accident near Dumas, Arkansas. The commercial pilot was not injured. The airplane was operated as a Title 14 Code of Federal Regulations Part 137 aerial application flight.

The pilot reported that after the completion of a low-level aerial application operation over a field, he executed a trim pass on the north side of the field with about 495 gallons (about 4,133 lbs) of product in the hopper. While flying from west to east, between "160 to 180" mph, the five-blade metal propeller impacted a galvanized metal bracket attached to the top of a 35 ft tall wooden power line pole. The bracket was about one ft wide and two ft long. One of the propeller blades separated about midspan from the impact. After the impact, there were "extreme" vibrations throughout the engine and airframe, and oil from the engine coated the front three windshield panels. The pilot attempted to clear the oil with the windshield wiper system with no avail.

The pilot maneuvered the airplane to perform an emergency landing to an east to west oriented dirt road, about a half mile north of where the wooden power line was located. The hopper load was not dumped before the landing. Due to the reduced visibility, the pilot landed while looking out the left window. Both wings impacted the ground during the landing sequence and the airplane came to rest over a ditch. The airplane sustained substantial damage to both wings and the rudder.

The pilot reported there were no preaccident mechanical failures or malfunctions with the airframe and engine that would have precluded normal operation. While the wooded power line pole was previously identified by the pilot, the pilot reported that he did not know about, nor did he see the metal bracket attached to the top of the wooden power line pole. The pilot further reported that he did not feel the glare of the sun, which was positioned 39° above the horizon and at an azimuth of 143°, was a factor in the accident.

The Federal Aviation Administration (FAA)-approved Air Tractor AT-602 Airplane Flying Manual (AFM) discusses general procedures for low-level aerial application flights, however the AFM does not contain guidance regarding post-obstacle strike actions (obstacles such as those commonly encountered in low-level aerial application flights such as a wire, pole, tower, or tree) and emergency hopper dump guidance, nor is such guidance required.

Data Source

Data provided by the National Transportation Safety Board (NTSB). For more information on this event, visit the NTSB Records Search website. NTSB# CEN20LA109