N4064X

On March 18, 2023, about 1000 central daylight time, an Aero Commander 100-180, N4064X was substantially damaged when it was involved in an accident near Gordonville, Texas. The pilot was not injured, and the passenger received minor injuries. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 personal flight.

The pilot reported that he was part of a group of 6 airplanes that had departed Wichita Falls, Texas, destined for Gordonville, Texas. According to the pilot, he was landing to the east with a quartering tailwind and was the last one in the group to land. The pilot had established an approach speed of about 80 knots and observed that the wind had ceased after the airplane descended below the trees that bordered the airport. As the main landing gear contacted the runway, the pilot and the passenger heard an unusual loud noise.

Two witnesses reported that the airplane was stabilized during its approach to land. One witness stated that when the nose gear touched down it rebounded and the nosewheel and strut “shot out” from the airplane. The airplane then slid about 30 ft before it nosed over and came to rest inverted.

Photographs from the Federal Aviation Administration showed substantial damage to the fuselage and rudder. In addition, the nose landing gear had separated at the cylinder (strut) and the nose landing gear scissor link was fractured. According to the pilot, the first point of impact was an impression in the grass from the nosewheel fairing followed by two gouges from the nosewheel strut. The strut gouges were followed by propeller striations and a narrow scar that was about 25 ft long that terminated near the airplane wreckage. The pilot also stated that the distance between the first point of impact and the accident site was about 100 yards.

The nosewheel fairing was also cracked at the bottom and was accompanied by a dirt mark.

According to the airplane maintenance manual,

“The nose landing gear strut outer body is welded to and becomes part of the engine mount assembly. The nose landing gear cylinder and piston fits upward through the strut outer body. An upper and lower strut bearing fits between the strut outer body and the strut cylinder, permitting the strut cylinder to rotate within the outer body…the lower strut bearing fits over the strut cylinder to ride against a machined collar on the cylinder. The cylinder is pulled up against this bearing to mate with the lower outer body sleeve…the compression of air and metering of oil through a hole in the top of the piston controls the flow of the oil from the cylinder assembly through the piston, allowing the piston to move through the oil with a resistance to shock loads. The strut cylinder is joined to the landing gear fork boss by the upper and lower scissor links.”

A National Transportation Safety Board Materials Laboratory examination revealed evidence of fatigue on the left side of the upper scissor link at the fracture face. There was insufficient evidence to determine the source of the fatigue crack.

The aircraft logbooks showed that on March 15, 2022, a “new torque link upper attachment bushing was installed on the nose strut.” According to the illustrated parts catalogue, there is a bushing installed at the bottom of the upper scissor link adjacent to the area that fractured at the ears. However, the bushing and its associated hardware remained attached and secure at the upper torque link.

The aircraft mechanic who performed the last annual inspection on the accident airplane and the replacement of the bushing stated that the scissor link holds the cylinder and piston to the strut. If the scissor link is disconnected, the nosewheel cylinder and fork will separate from the strut. The manual does not show any requirements for an inspection of the nose landing gear scissor link. However, appendix D to Title 14 Code of Federal Regulations Part 43 (the requirements for an annual/100hour inspection) states,

“Each person performing an annual or 100-hour inspection shall inspect the following components of the landing gear group:

(3) Linkages, trusses and members – for undue and excessive wear fatigue, and distortion”

Figure 1. Nose gear assembly from illustrated parts catalogue