N75775

Substantial
None

CESSNA 172NS/N: 17267941

Accident Details

Date
Sunday, May 4, 2025
NTSB Number
CEN25LA168
Location
Longmont, CO
Event ID
20250505200108
Coordinates
40.174833, -105.187500
Aircraft Damage
Substantial
Highest Injury
None
Fatalities
0
Serious Injuries
0
Minor Injuries
0
Uninjured
1
Total Aboard
1

Probable Cause and Findings

The disconnected throttle control that resulted in a loss of engine power due to improper maintenance.

Aircraft Information

Registration
Make
CESSNA
Serial Number
17267941
Engine Type
Reciprocating
Year Built
1976
Model / ICAO
172NC172
Aircraft Type
Fixed Wing Single Engine
No. of Engines
1
Seats
4
FAA Model
172N

Registered Owner (Current)

Name
ROCKY MOUNTAIN AIRCRAFT SERVICES LLC
Address
11750 AIRPORT WAY HNGR B12A
City
BROOMFIELD
State / Zip Code
CO 80021-2553
Country
United States

Analysis

On May 4, 2025, about 1200 mountain daylight time, a Cessna 172N airplane, N75775, was substantially damaged when it was involved in an accident near Longmont, Colorado. The student pilot was not injured. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 instructional flight.

The student pilot stated that he was on final approach when he noticed that the engine was not responding to his throttle control changes. The engine speed was about 2,000 rpm when he attempted a go-around. However, the engine power did not increase as he applied full throttle, and the airplane would not climb due to the low power setting. He noted that the engine subsequently lost power completely and he executed a forced landing to a field. During the landing, the airplane struck a fence and nosed over. The airframe sustained substantial damage to the right wing, vertical stabilizer, and rudder.

A post-accident examination conducted by a Federal Aviation Administration inspector determined that the throttle cable was disconnected from the carburetor. Both the throttle cable and the carburetor control arm moved freely and there was no evidence of damage to either component. The connecting hardware – bolt and nut – were not observed at the time of the examination.

Airplane maintenance records revealed that a 100-hour inspection was completed three weeks before the accident, and the engine carburetor was replaced at that time. The airplane had accumulated about 9.9 hours flight time since that maintenance. The mechanic noted that an apprentice had replaced the carburetor. He had gotten busy with other tasks and did not fully inspect the apprentice’s work.

Data Source

Data provided by the National Transportation Safety Board (NTSB). For more information on this event, visit the NTSB Records Search website. NTSB# CEN25LA168