N4NHQUICKSILVER II2026-01-20 NTSB Accident Report

Substantial
None

QUICKSILVER IIS/N: 0622

Summary

On January 20, 2026, a Heimberger Norm QUICKSILVER II (N4NH) was involved in an incident near Spring, TX. All 1 person aboard were uninjured.

This incident is documented in NTSB report CEN26LA097. AviatorDB cross-references NTSB investigation data with FAA registry records to provide comprehensive safety information for aircraft N4NH.

Accident Details

Date
Tuesday, January 20, 2026
NTSB Number
CEN26LA097
Location
Spring, TX
Event ID
20260122202331
Coordinates
30.057222, -95.551526
Aircraft Damage
Substantial
Highest Injury
None
Fatalities
0
Serious Injuries
0
Minor Injuries
0
Uninjured
1
Total Aboard
1

Aircraft Information

Registration
Make
QUICKSILVER
Serial Number
0622
Engine Type
2-cycle
Year Built
2010
Model / ICAO
II
Aircraft Type
Fixed Wing Single Engine
No. of Engines
1
Seats
2
FAA Model
QUICKSILVER II

Registered Owner (Current)

Name
MISSION AVIATORS LLC
Address
5231 COBBLE LN
City
SPRING
State / Zip Code
TX 77379-8040
Country
United States

Analysis

On January 20,2026, 1658 central standard time, a Quicksilver II, N4NH, sustained substantial damage when it was involved in an accident at David Wayne Hooks Memorial Airport, DWH, in Spring, Texas. The pilot, sole occupant, sustained no injuries. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 personal flight.

The pilot departed runway 17L with intentions of staying in the traffic pattern and making a water landing at the adjacent water runway at the airport. After retracting the landing gear, the engine ran very rough and lost power from the normal 6,500 rpm to about 1,800 rpm. The airplane was about 100 ft above ground level (agl) as the pilot lowered the nose and prepared for landing on the remaining runway. The airplane landed hard on the left side of the runway with the wings level and the landing gear still retracted. The airplane continued into the grass on the left side of runway 17L and came to rest near taxiway H. Just before touchdown, the engine power began to recover, and the engine returned to full power as the airplane was sliding on its floats. The pilot closed the throttle to idle, turned off the engine, and exited the airplane.

During the hard landing the aluminum tubes from the rear engine area to the main landing gear were bent. The engine was displaced aft and the propeller contacted the elevator control tube and severed it. The elevator control horn was fractured and the elevator trim cable was damaged by contact with the propeller. The pilot also reported that several aluminum structural tubes were bent. He stated that there was no other damage to the airplane.

The pilot, with the help of ground personnel, lowered the landing gear, and returned the airplane to the hangar for further inspection.

Data Source

Data provided by the National Transportation Safety Board (NTSB). For more information on this event, visit the NTSB Records Search website. NTSB# CEN26LA097