N3090C

Substantial
None

Ayres S2R-T34 S/N: T34-075DC

Accident Details

Date
Wednesday, December 13, 1995
NTSB Number
FTW96LA069
Location
WEST HELENA, AR
Event ID
20001207X05005
Coordinates
34.539318, -90.639968
Aircraft Damage
Substantial
Highest Injury
None
Fatalities
0
Serious Injuries
0
Minor Injuries
0
Uninjured
1
Total Aboard
1

Probable Cause and Findings

Binding of the power lever linkage, due to corrosion, which resulted in a situation that led to an inadvertent shut-down of the engine at a critical point on the approach to land. A factor relating to the accident was: inadequate maintenance.

Aircraft Information

Registration
N3090C
Make
AYRES
Serial Number
T34-075DC
Engine Type
Turbo-shaft
Year Built
1983
Model / ICAO
S2R-T34 A660
Aircraft Type
Fixed Wing Single Engine
No. of Engines
1

Registered Owner (Historical)

Name
SOUTHER CROP SPRAYING INC
Address
640 INDIAN CREEK XING
Status
Deregistered
City
DOUGLAS
State / Zip Code
GA 31535-4700
Country
United States

Analysis

On December 13, 1995, at 1115 central standard time, an Ayers S2R-T34, N3090C, registered to Morrison Enterprises, and operated by Louisiana Delta Plantation as a Title 14 CFR Part 91 ferry flight, was substantially damaged during a forced landing near West Helena, Arkansas. Visual meteorological conditions prevailed, and a flight plan was not filed. The commercial pilot was not injured. The flight originated from Jonesville, Louisiana, about one hour before the accident.

The pilot reported to a FAA inspector that, the airplane was being ferried to West Helena to comply with an annual inspection. As the airplane approached the destination airport, he attempted to retard the power to enter the traffic pattern. The power lever would not respond to any input.

The pilot further reported that, he made three attempts to land, but was unable since he was not able to slow the airplane below 135 knots. The pilot also stated that on his fourth attempt to land, he elected to move the condition lever from flight idle to ground idle. However, it inadvertently went past the idle stop and the engine lost power. The airplane landed short of the runway and impacted trees resulting in structural damage to the wings and engine mount.

The pilot reported in the Pilot/Operator Report the following information. An examination of the fuel control system revealed the fuel control linkage was corroded. The aircraft is washed at the end of each work day, and the control linkage is lubricated on a regular basis. However, the pilot recommends the control linkage should be lubricated daily after fertilizer or any other corrosive material is used.

Data Source

Data provided by the National Transportation Safety Board (NTSB). For more information on this event, visit the NTSB Records Search website. NTSB# FTW96LA069