N79SP

HISTORY OF FLIGHT

On April 4, 1996, at 1019 eastern standard time, a Bell 206L-1, a helicopter, N79SP, owned and operated by the West Virginia State Police, was destroyed during an in-flight break-up and collision with terrain, 2.5 miles west of the Yeager Airport, Charleston, West Virginia. The commercial pilot and passenger were fatally injured. Visual meteorological conditions prevailed for the positioning flight that originated at the Yeager Airport (CRW), at 1016. No flight plan had been filed for the flight conducted under 14 CFR Part 91.

The State Police pilot and passenger departed the State Police Academy where the helicopter was based, and flew a 1.5 hour flight. The helicopter was landed at CRW, refueled, and departed in a westerly direction for the return flight to the academy. About 1019, a garbled transmission with an ELT signal in the background was received by a CRW Air Traffic Controller. When the controller attempted contact with N79SP, there was no response.

Forty-four witnesses observed the helicopter during various segments of the accident sequence, and many observed the helicopter in level flight about 300 feet above a hill before the event began. Twenty-one witnesses stated that they observed something depart from the tail of the helicopter, followed by the helicopter entering a spin, rolling inverted, and descending into trees. Two of the witnesses stated that they observed the helicopter collide with birds. One of these witnesses stated, "...I did not see anything fall off or break off of the aircraft other than the bird which fell off to the right..." A third witness stated, "...I saw a big dark piece of something, that I originally thought might have been a bird, come off of the helicopter. The piece then seemed to move back into the rotor on top and the helicopter started going down..."

Another witness stated:

"...I saw something fly off ...it looked like it flew up into the propeller because it then ricocheted away from the helicopter...There were papers from it that blew over by where I was working. The wind blew them there eventually. It seemed to be flying normal to the point that something flew off of it. It was flying slow. I didn't notice any birds flying around it..."

Fourteen other witnesses described their observations:

"...I didn't notice anything unusual about the sound of the helicopter or the way it was flying that day until it got to the top of the hill...then I saw part of the rear tail section fall off and then the helicopter went into a left bank and did a complete 360 degree;...something black and square looking fell off the side of the helicopter;...I observed a piece of the aircraft fly off;...Something fell behind the helicopter that made a noise when it broke and hit the tail;...I saw one of the main blades come off and shoot straight out. The helicopter turned again and the rotor came off;...the tail end blew off and it was like it went off the back and then dropped straight down. The helicopter then made a 360 degree rotation;...I saw the top propeller fly off;...I saw something fly off the helicopter. It looked like it came form the middle, then I saw something come from the back. It looked like a piece of metal;...I noticed something fall off the rear. At this time the helicopter was still going forward but was wobbling;...I noticed something black about the size of a basketball fall off the helicopter;...I saw something falling from the rear of the helicopter. It looked to be pretty good size;...I looked up and [saw] the tail fin drop off;...As he was going down, papers were flying out of it;...When we first saw it, it drew our attention and nothing appeared to be out of the ordinary. He dropped down a little bit, and tried to pull himself back up, then it looked like his tail end fell off. He started to twirl then went straight down..."

The helicopter struck the ground inverted, and a post crash fire erupted. The accident occurred during the hours of daylight at approximately 38 degrees, 23 minutes north latitude, and 81 degrees, 39 minutes west longitude.

PERSONNEL INFORMATION

The pilot, Mr. Charles M. Turner, held a Commercial Pilot Certificate with an instrument rating for rotorcraft-helicopter, and a Private Pilot Certificate for airplane single engine land.

His most recent Federal Aviation Administration (FAA) Second Class Medical Certificate was issued on February 29, 1996.

A review of Mr. Turner's pilot log book revealed that he had logged approximately 4,535 hours of total flying experience, of which about 4,400 hours were in helicopters, and 2,500 hours were in this make and model

WRECKAGE AND IMPACT INFORMATION

The helicopter wreckage was examined at the accident site on April 4 and 5, 1996. It was then removed to a hangar and examined further. The examination revealed that all major components of the helicopter were accounted for; however, several components were separated from the main fuselage and located up to 1,400 feet to the east.

The main fuselage was inverted on the east slope of a ravine, at an approximate elevation of 820 feet above mean sea level (msl). The height of the highest terrain in the area was over 1,020 feet msl, and the bottom of the ravine was about 740 feet msl.

Debris located about 1,400 feet east of the fuselage included; shredded papers from the cockpit; blue paint chips and sheet metal that were matched to the nose battery compartment area of the fuselage; sections of brown plastic that were matched to the cockpit overhead circuit breaker panel; and a 6 inch long black and yellow paint chip that was matched to a position on the (red) main rotor blade, 3 feet from the hub end of the blade.

The tail boom section, aft of center of gravity (CG) station 362 (boom station 167), was located about 650 feet east of the main fuselage. This included the upper and lower vertical fin, the tail rotor gear box, and the tail rotor hub and blades. The tail section at station 362 was torn and twisted, and no external impact marks were visible on the sheet metal. Both tail rotor blades were bent chord wise. The bend in the white blade was 4 inches from the hub and displayed aft compression wrinkles at the bend. The bend in the red blade was 2 inches from the hub. The white blade had an indentation 1/2 inch deep in the leading edge, about 4 inches from the end of the blade. The white blade also displayed several chord wise scratches at the leading edge, similar to the rivet pattern on the right side of the tail boom.

The tail rotor output shaft turned freely, and continuity was observed to the input shaft when the tail rotor was turned. The splines inside of the input shaft were intact and not damaged. Rotational scratches and scoring were observed on the inside of the tail rotor drive shaft cover.

The upper and lower vertical fins were intact. The upper vertical fin had a 1/2 inch indentation on its leading edge, about 5 inches from the top of the fin.

The main rotor hub and blades were separated from the main transmission mast. The hub and the attached sections of main rotor blades were located about 100 feet southeast, up slope, from the main wreckage. The mast separation displayed torsional overload, and had separated at the yoke dynamic stop. The leading edges of both main rotor blades remained attached to the rotor hub; however, several sections of both blades were separated and located up to 400 feet from the hub. One section of the (red) main rotor blade was found 300 feet east of the main fuselage. On the ground next to this section of blade was a piece of the battery cover, with an indentation similar to the leading edge of the main rotor blades.

The collective sleeve and swashplate were separated from the transmission mast and located about 25 feet northeast of the main fuselage. The main transmission was intact and the mast rotated freely. The two transmission chip detector plugs were examined and found absent of metal. All flight control tubes examined displayed overload separation.

The main fuselage was inverted, and partially consumed by post crash fire. All pilot, passenger, cargo and inspection doors were accounted for in the vicinity of the main fuselage. The nose mounted high intensity spot light was found in the main wreckage, and the Forward Looking Infrared Radar (FLIR) unit was located 40 feet north, and down slope, from the main wreckage.

The tail boom remained attached to the fuselage and displayed wrinkling, with a right twist near the fuselage attaching points. The tail boom sheet metal near the separation point at CG station 362 was torn with a right twist in the metal.

The engine received extensive damage during impact and post crash fire.

Several components of the main rotor head, tail boom, and three hydraulic control servos were removed for further examination.

MEDICAL AND PATHOLOGICAL INFORMATION

An autopsy was performed on Mr. Charles Turner, on April 5, 1996, by Dr. Irvin M. Sopher, of the Office of Chief Medical Examiner, South Charleston, West Virginia.

The toxicological testing reports from the FAA Toxicology Accident Research Laboratory, Oklahoma City, Oklahoma, and the Office of the Chief Medical Examiner, was negative for drugs and alcohol for Mr. Charles Turner.

TESTS AND RESEARCH

Components of the main rotor head and tail boom were examined at the National Transportation Safety Board Materials Laboratory, Washington, D.C. The metallurgist examination revealed that in the area of the separation, the tail boom was made of two semicircular pieces of skin that were overlapped and longitudinally riveted. Looking forward, one piece of the tail boom skin extended from about the 7:30 o'clock position to about the 1:30 o'clock position along the left and top surface of the boom and was referred to as the t...