N467SR

Substantial
None

Cessna 150H S/N: 150-69050

Accident Details

Date
Tuesday, September 2, 1997
NTSB Number
ANC97LA141
Location
YAKUTAT, AK
Event ID
20001208X08766
Coordinates
59.510574, -139.710128
Aircraft Damage
Substantial
Highest Injury
None
Fatalities
0
Serious Injuries
0
Minor Injuries
0
Uninjured
1
Total Aboard
1

Probable Cause and Findings

A partial blockage of the main fuel supply line to the engine, caused by improper manufacture of the fuel line by unknown maintenance personnel.

Aircraft Information

Registration
N467SR
Make
CESSNA
Serial Number
150-69050
Engine Type
Reciprocating
Year Built
1968
Model / ICAO
150H C150
Aircraft Type
Fixed Wing Single Engine
No. of Engines
1

Registered Owner (Historical)

Name
WARREN ROY A
Address
PO BOX 32362
Status
Deregistered
City
JUNEAU
State / Zip Code
AK 99803
Country
United States

Analysis

On September 2, 1997, at 1000 Alaska daylight time, a Cessna 150H airplane, N467SR, sustained substantial damage when it nosed over during an aborted takeoff from a private airstrip on the Akwe River, 30 miles southeast of Yakutat, Alaska. The private certificated pilot was uninjured. The flight was conducted under 14 CFR Part 91 as a personal flight, and was departing the Akwe River for Juneau, Alaska. Visual meteorological conditions prevailed at the time of the accident, and no flight plan was filed.

The pilot stated that just after takeoff from the 1,800 feet by 50 feet sand airstrip, while accelerating in ground effect, the engine lost partial power and he was unable to climb. The pilot intentionally attempted to land back on the strip. He pulled the mixture control to idle cutoff, and turned off the magnetos and electrical master switch. The airplane was not stopped prior to the end of the strip, the nose wheel broke off, and the airplane nosed over.

Postaccident inspection by an FAA airworthiness inspector revealed an internal blockage in the main fuel supply line to the carburetor. A flap of rubber material protruded from the point where the flexible line was joined to an end fitting. It was estimated by the FAA inspector, that this flap would intermittently block approximately 60% of the fuel line inner diameter, based on fuel flow. The fuel line and fittings appeared to be an assembly built from aircraft grade parts by an unknown mechanic, but not of factory construction. Review of the aircraft and engine logbooks did not reveal when this assembly was installed.

Data Source

Data provided by the National Transportation Safety Board (NTSB). For more information on this event, visit the NTSB Records Search website. NTSB# ANC97LA141