N56484

HISTORY OF FLIGHT

On January 11, 2003, about 1100 Pacific standard time, a Piper PA-34-200, N56484, made a forced landing in Westlake Village, California, following a loss of power in the right engine. The Aero Club was operating the airplane under the provisions of 14 CFR Part 91. The certified flight instructor (CFI) and the private pilot undergoing instruction (PUI) sustained serious injuries; the airplane was destroyed. The local instructional flight departed Van Nuys, California, about 0945. Visual meteorological conditions prevailed, and no flight plan had been filed.

The Federal Aviation Administration (FAA) accident coordinator interviewed the pilots. The CFI said that start, taxi, run up, and takeoff were uneventful. The lesson plan called for practice simulated engine-out maneuvers. The CFI said that he simulated engine loss of power by retarding the mixture control. Once the student identified the loss of power, the CFI simulated zero-thrust by setting the manifold pressure to 23 inches of Mercury, and the engine to 2,300 revolutions per minute (rpm). The PUI completed two simulated loss of power events.

The CFI said that he was reaching for the mixture control for a third simulation when he heard a loud bang. The airplane yawed violently to the right and began to lose altitude. The CFI looked out of the right window at the right engine. He did not recall seeing a propeller either stopped or rotating. He was not sure that the engine was there. The PUI informed the CFI that he was unable to maintain control, and told the CFI to take the controls.

The CFI turned toward his home field, but he was having difficulty maintaining altitude. He decided that he would not be able to make it to the airport, and would have to make an off field landing. He landed in the only clear spot that he could see, which was a cemetery. The airplane collided with monuments and a wood chip pile before coming to rest next to a mausoleum.

PERSONNEL INFORMATION

A review of FAA airman records revealed that the CFI held a commercial pilot certificate with airplane single engine and multiengine land ratings and an instrument airplane rating. The pilot held a certified flight instructor certificate with ratings for airplane single engine and multiengine land and instrument airplane.

The CFI held a second-class medical certificate issued on August 30, 2003. It had the limitations that the pilot must have glasses available for near vision.

No personal flight records were available for the CFI. The National Transportation Safety Board investigator-in-charge (IIC) obtained the aeronautical experience listed in this report from a review of the FAA airman medical records on file in the Airman and Medical Records Center located in Oklahoma City, Oklahoma. These records indicated a total time of 3,500 hours.

A review of FAA airman records revealed that the PUI held a private pilot certificate with an airplane single engine land rating. The PUI held a second-class medical certificate issued on June 22, 2001. It had no limitations or waivers. A review of the PUI's logbooks indicated an estimated total flight time of 145 hours. He had an estimated 6 hours of dual flight instruction in this make and model.

AIRCRAFT INFORMATION

The airplane was a Piper PA-34-200, serial number 34-7350338. The logbooks contained an entry for an annual inspection dated July 26, 2002. The left tachometer read 257.0 at the last inspection; the right tachometer read 156.6 at the last inspection. The left tachometer read 513.4 at the accident scene; the right tachometer read 411.3 at the accident scene.

The left engine was a Textron Lycoming IO-360-C1E6 engine, serial number L20922-51A. Total time on the engine was approximately 6,740 hours since a factory overhaul.

The right engine was a Textron Lycoming LIO-360-C1E6 engine, serial number RL-1115-67A. Total time on the engine was approximately 6,400 hours since a factory remanufacture.

The FAA accident coordinator obtained records, which indicated that Sky Trails at Van Nuys fueled the airplane with 51.9 gallons of 100 LL aviation fuel at 0935 on the morning of the accident. The coordinator interviewed the refueling operator who said that he filled the tanks.

TESTS AND RESEARCH

The IIC, the FAA accident coordinator, and investigators from Piper, Textron Lycoming, and Hartzell Propellers examined the wreckage at Aircraft Recovery Service, Littlerock, California, on January 15, 2003. The left engine separated from the airplane during the collision sequence. Retrievers cut wires and cables to remove the right engine.

LEFT ENGINE

Investigators slung the left engine from a hoist, and removed the top spark plugs. All spark plugs were clean with no mechanical deformation. The spark plug electrodes for all cylinders were gray in color, which corresponded to normal operation according to the Champion Aviation Check-A-Plug AV-27 Chart.

A borescope inspection revealed no mechanical deformation on the valves, cylinder walls, or internal cylinder head.

Investigators rotated the engine manually, but encountered mechanical damage and it bound after approximately 30 degrees of rotation.

Investigators manually rotated the magnetos, and both magnetos produced spark at all posts.

The fuel injector screen contained a fluid that smelled like aviation gasoline. The fuel manifold lines and nozzles were unobstructed.

The oil filter and the oil suction screen contained shiny debris that was not attracted to a magnet.

The No. 1 and No. 2 main bearings were unremarkable. The main bearing for the No. 3 journal did not have a tang and had a smooth polished appearance. It exhibited rotational scoring on the outer surface where it seated in the bearing saddle. The bearing had pits and was delaminating with areas that were missing material. The main bearing for journal No. 4 had pits.

Left Propeller

The left propeller was a Hartzell model HC-C2YK-2CGUF, serial number AU1440. Both propeller blades bent aft and exhibited trailing edge gouges. Both tips curled aft, and toward the low pitch position.

The Hartzell representative examined the left propeller. He determined that the left propeller was rotating, and not feathered at the time of impact. He could not determine the amount of power. He noted no discrepancies that would have precluded normal operation. He did not inspect the propeller vibration dampers.

RIGHT ENGINE

Investigators slung the right engine from a hoist, and removed the top spark plugs. All spark plugs were clean with no mechanical deformation. The spark plug electrodes for cylinders No. 1 and No. 3 were gray in color, which corresponded to normal operation according to the Champion Aviation Check-A-Plug AV-27 Chart. The spark plugs for cylinders No. 2 and No. 4 were oily. The engine lay on its left side during recovery.

A borescope inspection revealed no mechanical deformation on the valves, cylinder walls, or internal cylinder head.

Investigators manually rotated the engine using a tool in an accessory drive socket. The crankshaft rotated freely, and the valves moved approximately the same amount of lift in firing order. The vacuum pump drive gear remained unbroken, and the vacuum pump turned freely. The fuel pump plunger moved up and down, and the gears in the accessory case turned freely. Investigators obtained thumb compression on all cylinders in firing order.

The fuel pump's rubber diaphragm was unbroken and investigators blew air through the lines. The plunger in the fuel distribution valve moved freely, the rubber diaphragm was unbroken, and investigators did not observe any contamination. The fuel nozzles were open, and the screens were clean.

The right magneto sustained mechanical damage, and investigators did not test it. Investigators manually rotated the left magneto and obtained spark at all posts.

The oil suction screen and the oil filter contained shiny debris. A magnet attracted about 90 percent of the material in the oil filter. Debris filled about 50 percent of the oil suction screen. A magnet attracted some of the debris. The governor screen was clean.

The Safety Board Materials Laboratory examined a sample of the debris. The specialist's report is part of the public docket. Pertinent parts of the report follow.

The material from the right engine oil suction screen consisted for the most part of thin fragments with lateral dimensions ranging from about 0.02 inch to 0.5 inch. The fragments were generally of three different types: a shiny light-colored material of irregular shape, a darker material of irregular shape, or a darker material with a roughly rectangular shape. The specialist labeled three representative pieces showing the three different types as Sample A, Sample B, and Sample C. X-ray energy dispersive spectroscopy of Sample A revealed spectra having a major peak for aluminum with minor peaks for copper, tin, silicon, carbon, iron, and nickel. The spectra from Samples B and C were nearly identical, with a major peak for iron and minor peaks for lead, bromine, and carbon.

Right Propeller

The right propeller was a Hartzell HC-CYK-2CLGUF, serial number DN2543. The right propeller hub fractured and separated. Investigators did not recover one blade and part of the hub.

The Hartzell representative examined the right propeller. Missing parts included: one complete blade assembly, part of the hub, the piston, feather spring, cylinder, start lock mechanism, and forward half of the pitch change rod. The remaining blade had no indications of rotation at the time of impact. He did not inspect the propeller vibration dampers.

The Safety Board Materials Laboratory examined the hub remnant and prepared a factual report. Pertinent parts of the report follow; the complete report is part of the public docket.

The propeller blades were Hartzell model FJC7666A, with serial numbers reported as J55500 and J55...