N70SR

On October 7, 2006, at 1300 central daylight time, a Piper PA-28R-180, N70SR, registered to Shelby Air LLC, operating as a 14 CFR Part 91 instructional flight, collapsed the right main landing gear during landing on runway 15 at the Shelby County Airport, in Alabaster, Alabama. Visual meteorological conditions prevailed, and no flight plan was filed. The airplane received substantial damage. The private pilot reported no injuries. The flight originated from Shelby County Airport on October 7, 2006, at 1200.

The pilot stated that he was practicing in preparation for his commercial pilot certificate. On the initial takeoff, after raising the gear, the pilot noticed the gear in-transit light remained on. The pilot pulled the landing gear pump circuit breaker. When he reset the breaker, he did not see a movement on the amp meter. He said this was an indication that the pump was not running. Although the in-transit light remained on, the pilot stated that the gear was up and locked. The pilot continued on to the practice area to do some air work, then he returned to the airport to do some touch-and-go landings. The pilot stated that on the first landing the gear went down normally and he had three green lights. On the take off he said the gear would not go up and lock. He cycled the gear handle several times. The pilot stated he had three green lights and the gear in-transit light was still on. The pilot stated the light was on for the entire flight. He said that he made a normal touch-down, and the right main gear collapsed veering the airplane to the right, off the runway, damaging the right wing, right main gear, and nose-wheel.

Examination of the airplane by an FAA Inspector found the nose and right main landing gear collapsed and structural damage to the wing ribs at the right main landing gear attach point. The airplane was placed in a hangar and jacked up for a retraction test. The gear handle was placed in the up position and the gear raised normally and the in transit light was not on when the gear was up and locked. When the gear handle was placed in the down position the hydraulic pump operated but the gear did not extend. The landing gear remained up and locked. Striking the pump with a hammer freed the shuttle valve and the gear operated normally. According to the FAA Inspector the gear would not extend normally without striking the shuttle valve with a hammer.

A completed NTSB Form 6120.1/2, Pilot/Operator Report, was not received from the pilot or aircraft operator.