N1KU

Substantial
None

PIPER PA-28R-200S/N: 28R-7135161

Accident Details

Date
Wednesday, March 17, 2010
NTSB Number
WPR10LA165
Location
Eliza Island, WA
Event ID
20100320X91951
Coordinates
48.653888, -122.586944
Aircraft Damage
Substantial
Highest Injury
None
Fatalities
0
Serious Injuries
0
Minor Injuries
0
Uninjured
2
Total Aboard
2

Probable Cause and Findings

The total loss of engine power during cruise flight due to the failure of maintenance personnel to tighten a fitting on the propeller governor oil line, which resulted in a loss of engine oil and catastrophic engine failure.

Aircraft Information

Registration
N1KU
Make
PIPER
Serial Number
28R-7135161
Engine Type
Reciprocating
Year Built
1971
Model / ICAO
PA-28R-200P28R
Aircraft Type
Fixed Wing Single Engine
No. of Engines
1

Registered Owner (Historical)

Name
PRATER KEITH B
Address
1088 224TH ST
Status
Deregistered
City
LANGLEY BC
State / Zip Code
V2Z 2-W6
Country
United States

Analysis

On March 17, 2010, approximately 1100 Pacific daylight time, a Piper Arrow PA-28R-200, N1KU, sustained substantial damage during a forced landing following a loss of engine power near Eliza Island, Washington. The private pilot/owner and the pilot-rated passenger were not injured. The owner was operating the airplane under the provisions of 14 Code of Federal Regulations Part 91. Visual meteorological conditions prevailed for the local maintenance test flight, which had been airborne for approximately 15 minutes. A flight plan had not been filed; the flight departed from Bellingham, Washington.

The pilot/owner stated that the airplane had just been annually inspected and was signed off on February 24, 2010. Due to bad weather and other commitments, he could not perform a maintenance flight until March 17, 2010. On that day, he invited a fellow pilot and occasional flight instructor to join him. During their extensive preflight, it was noted that the engine crankcase contained 7 quarts of oil. The engine start and taxi out were normal; the before takeoff run-up was "a bit longer than usual," which gave time to confirm good engine oil pressure. The magnetos checked normal and the propeller cycled normally.

The pilot/owner performed the takeoff and climbed to 4,800 feet. After 8 to 10 minutes of flight, the propeller went to low pitch and the engine to high rpm. The propeller did not respond to the propeller control. A forced landing spot was selected to a grass strip on a small island. The engine began making metal grinding noises and vibrating heavily. Soon thereafter, the engine froze and the propeller stopped. The pilot-rated passenger took control of the airplane and performed a forced landing. During this time, the airplane's automatic landing gear extension system lowered the landing gear earlier than the flying pilot had planned. The airplane landed short of the runway, and struck a 3-foot-high beach piling with its right wing root. The fuselage was twisted, and both wings were bent and wrinkled.

Examination of the engine revealed that the crank case was cracked and the bottom of the fuselage was covered with oil. After aircraft recovery to a salvage yard, a National Transportation Safety Board investigator examined the engine on April 7, 2010. He found that the fitting which attached the propeller governor high pressure oil line from the nose of the crankcase to the propeller governor was loose. Maintenance records indicated that during the annual inspection, the propeller governor on the engine's accessory section had been removed so that its gasket could be replaced.

Data Source

Data provided by the National Transportation Safety Board (NTSB). For more information on this event, visit the NTSB Records Search website. NTSB# WPR10LA165