N31281

Substantial
None

BELLANCA 7ECAS/N: 888-72

Accident Details

Date
Sunday, November 4, 2012
NTSB Number
ANC13LA008
Location
Kenai, AK
Event ID
20121104X91214
Coordinates
60.573333, -151.244720
Aircraft Damage
Substantial
Highest Injury
None
Fatalities
0
Serious Injuries
0
Minor Injuries
0
Uninjured
1
Total Aboard
1

Probable Cause and Findings

The loss of engine power due to carburetor icing and the pilot's failure to apply carburetor heat when he reduced engine power.

Aircraft Information

Registration
Make
BELLANCA
Serial Number
888-72
Engine Type
Reciprocating
Year Built
1972
Model / ICAO
7ECAB407
Aircraft Type
Fixed Wing Single Engine
No. of Engines
1
Seats
2
FAA Model
7ECA

Registered Owner (Current)

Name
CITABRIA 1972 LLC
Address
33895 KEYSTONE DR
City
SOLDOTNA
State / Zip Code
AK 99669-8534
Country
United States

Analysis

On November 4, 2012, about 1230 Alaska standard time, a Bellanca 7ECA airplane, N31281, sustained substantial damage during an off-airport forced landing just after takeoff from the Kenai Municipal Airport, Kenai, Alaska. The airplane was being operated by the pilot as a visual flight rules (VFR) postmaintenance check flight, under the provisions of Title 14 Code of Federal Regulations (CFR) Part 91, when the accident occurred. The solo pilot was not injured. Visual meteorological conditions prevailed, and no flight plan was filed for the local area flight.

During a telephone conversation with the National Transportation Safety Board (NTSB) investigator-in-charge (IIC) on November 4, the pilot reported that the purpose of the flight was to do a check flight after a recently completed annual inspection. He also said that two engine cylinders had been replaced during the inspection, and he intended to fly the airplane in the local area, to "run in" the new cylinders, and return the airplane to service.

In the pilot’s written statement to the NTSB, dated November 6, he said that before departure he completed a thorough preflight inspection and pre-heated the airplane. He noted that the engine started easily and ran smoothly. Following a 45 minute run-up, the engine was shut down and inspected for oil leaks. He restarted the engine, intending to do a 1 hour check flight.

After takeoff, the pilot said he climbed the airplane tp the northeast, and then leveled off at 900 feet, which was followed by a loss of all engine power. In an attempt to restart the engine, he applied carburetor heat and switched fuel tanks, but he was unable restore engine power, and he selected an area of rough and uneven, tundra-covered terrain as a forced landing site. During touchdown the airplane sustained substantial damage to the empennage and fuselage.

Due to the location of the airplane the NTSB did not examine the airplane. After the airplane was recovered, a postaccident engine examination was accomplished, and no preaccident mechanical anomalies were found. The engine was subsequently started and operated with no mechanical problems noted.

The pilot noted that the loss of engine power was likely due to carburetor ice following the long ground run before takeoff.

According to an FAA carburetor icing chart, given the temperature and dew point at the time of the accident, carburetor ice is likely at glide and cruise power settings.

Data Source

Data provided by the National Transportation Safety Board (NTSB). For more information on this event, visit the NTSB Records Search website. NTSB# ANC13LA008