N107BL

Substantial
None

Cessna 337S/N: 33701330

Accident Details

Date
Saturday, June 30, 2018
NTSB Number
CEN18LA246
Location
Baldwin City, KS
Event ID
20180701X65752
Coordinates
38.836112, -95.181945
Aircraft Damage
Substantial
Highest Injury
None
Fatalities
0
Serious Injuries
0
Minor Injuries
0
Uninjured
1
Total Aboard
1

Probable Cause and Findings

The loss of hydraulic accumulator pressure for reasons that could not be determined, which prevented the propeller from unfeathering, and the pilot's improper decision to attempt a go-around, which resulted in an off-airport landing and the airplane impacting trees and a fence. Contributing to the accident was the loss of tension at the flap switch pivot, which prevented it from holding position.

Aircraft Information

Registration
Make
CESSNA
Serial Number
33701330
Engine Type
Reciprocating
Year Built
1970
Model / ICAO
337C337
Aircraft Type
Fixed Wing Multi Engine
No. of Engines
2
Seats
6
FAA Model
337F

Registered Owner (Current)

Name
VINLAND AERODROME INC
Address
696 E 1700TH RD
City
BALDWIN CITY
State / Zip Code
KS 66006-7351
Country
United States

Analysis

***This report was modified on November 7, 2019. Please see the docket for this accident to view the original report.***

On June 30, 2018, about 1155 central daylight time, a Cessna 337F, N107BL, a multiengine centerline thrust airplane, was substantially damaged when it struck trees and a fence during a forced landing about one mile southeast of Vinland Valley Aerodrome (K64), Baldwin City, Kansas. The commercial pilot was not injured. The airplane was registered to and operated by Vinland Aerodrome, Baldwin City, Kansas, under the provisions of Title 14 Code of Federal Regulations Part 91. Visual meteorological conditions prevailed at the time of the accident, and no flight plan had been filed for the local personal flight.

According to the pilot, who is also an airframe and powerplant (A&P) mechanic, he took off and climbed to 3,500 ft to practice single-engine operations. He shut down the rear engine and feathered the propeller. After doing some air work, the pilot attempted to unfeather the propeller and restart the rear engine but was unsuccessful. He returned to the airport and made a single-engine landing approach.

During the approach, the pilot noticed [he had lost his] full flap down setting and determined a full stop landing on the grass runway was going to be close. He reduced flaps to 10°. The flap setting "relaxed" and the pilot determined there was insufficient altitude available to retract the landing gear. The pilot maneuvered to avoid houses and made a forced landing in a crosswind. Full power and full flaps were used until touchdown. The airplane struck small trees, shrubs, and a fence. The left wing was bent and the fuselage was buckled.

The rear engine propeller has a remote hydraulic accumulator that assists in unfeathering the propeller and is serviced to 120 psi. During annual inspection 4 hours prior to the accident flight, it was found to be slightly low. Post-accident examination revealed the pressure to be 85 psi. It is most likely a nitrogen leakage had developed during those 4 hours. The flap switch was not holding position; the reason for this anomaly could not be determined.

Data Source

Data provided by the National Transportation Safety Board (NTSB). For more information on this event, visit the NTSB Records Search website. NTSB# CEN18LA246