N3078G

On July 13, 2019, about 1430 mountain daylight time, a Bell 47G-3B-1 helicopter, N3078G, was substantially damaged when it was involved in an accident near Mosby, Montana. The pilot and one passenger received serious injuries; one passenger received minor injuries. The helicopter was operated as a Title 14 Code of Federal Regulations Part 91 aerial observation flight.

Before departing on the 15-mile flight, the pilot fueled the helicopter, bringing the total fuel quantity to about 58 gallons. After arriving at the destination, the pilot circled the landing area to determine the wind conditions. Concluding that the wind was light and from the west, he entered a normal approach into the wind to land near the building where the helicopter would be stored following the flight. During the approach, the helicopter entered an uncommanded yaw to the right. Despite the pilot’s control inputs, which included full left pedal application, the helicopter continued to yaw to the right. He attempted to recover by applying forward cyclic control to gain airspeed and then perform a go-around. The pilot recalled lowering the collective control when the event first started, but did not recall if he raised or lowered the collective control during the go-around attempt. He stated that the controls felt like they were ineffective and that the helicopter descended straight down and impacted the ground hard.

One passenger stated that the helicopter pitched from side to side and then the tail came around twice. He stated that the pilot tried to climb and as the helicopter was going up, it was still spinning. The other passenger recalled that they were approaching the building and the helicopter swung to the right and started to ascend above the building. A witness located near the building reported that the helicopter approached from the east and looked normal until it was about 30 to 40 ft above the ground. He said that the helicopter turned right, then left, and back to the right before it ascended and flew directly over his position. The witness photographed the helicopter as it began to yaw to the right. (see Figure 1.)

Figure 1. Photograph of the helicopter as it began the uncommanded right yaw. Photo courtesy of a witness.

The helicopter came to rest in a level attitude in a silage pit located about 250 ft north of the intended landing area, at an elevation of 2,856 ft above mean sea level (msl). All major components were found in the small debris area around the helicopter.

Postaccident examination of the airframe revealed no preaccident mechanical malfunctions or failures with the helicopter that would have precluded normal operation. The engine was examined and test run at a Rolls-Royce authorized service facility and operated normally, with no mechanical malfunctions or failures that would have precluded normal operation.

A review of the pilot’s training records revealed that he had recorded about 1,092 hours of flight experience in reciprocating engine helicopters. According to the operator, after the pilot was hired, he began training to operate the turbine-powered Bell 47G-3B-1. He received 18 hours of ground instruction, 4 hours of flight training, and an additional 6 hours of solo flight time in the helicopter. He accrued an additional 15.5 flight hours during the aerial observation flights before the accident.

An automated weather reporting station located at Lewiston Municipal Airport, about 84 miles west of the accident site, reported wind from 080° at 7 knots, 10 statute miles visibility, clear sky condition, temperature 31°C, dew point temperature 12°C, and an altimeter setting of 30.00 inches of mercury. The calculated density altitude for the accident site about the time of the accident was about 5,406 ft msl.

A weather reporting station located about 5 miles northeast of the accident site reported wind from 160° at 7 knots, temperature 31°C, dewpoint temperature 15°C.

The Federal Aviation Administration Helicopter Flying Handbook (FAA-H-8083-21B) states the following regarding loss of tail rotor effectiveness (LTE), also referred to as “uncontrolled right yaw”:

LTE is a condition that occurs when the flow of air through a tail rotor is altered in some way, by altering the angle or speed at which the air passes through the rotating blades of the tail rotor disk.

To help reduce the onset of LTE, follow these steps:

Avoid OGE [out of ground effect] operations and high-power demand situations below airspeeds of 30 knots at low altitudes.

A loss of translational lift results in an unexpected high-power demand and an increased antitorque requirement.

Be aware that if a considerable amount of left pedal is being maintained, a sufficient amount of left pedal may not be available to counteract an unanticipated right yaw.

Be alert to changing wind conditions, which may be experienced when flying along ridge lines and around buildings.

Recovery technique (Uncontrolled Right Yaw). If a sudden unanticipated right yaw occurs, the following recovery technique should be performed. Apply full left pedal. Simultaneously, apply forward cyclic control to increase speed. If altitude permits, reduce power… If the rotation cannot be stopped and ground contact is imminent, an autorotation may be the best course of action.