N365EM

On July 16, 2019, about 1321 Pacific daylight time, an experimental, amateur built Vans RV 14A airplane, N365EM, was destroyed in an accident near Aumsville, Oregon. The pilot sustained minor injuries. The airplane was operated under the provisions of Title 14 Code of Federal Regulations Part 91 as a personal flight.

The pilot departed Aurora State Airport (UAO), Aurora, Oregon at 1235, with the intended destination to Corvallis Municipal Airport (CVO), Corvallis, Oregon. The pilot reported that about 1 hour into the flight, at a cruise altitude of 1,500 ft above ground level, he lost all electrical instrumentation and smelled burning wiring. He initiated an emergency descent a few seconds later when the smoke began to fill the cockpit and the fire started to enter the lower part of the cockpit by the left side rudder pedals. He conducted a forced landing to a field and evacuated the airplane that continued to burn until the first responders extinguished the fire.

The pilot informed investigators that the day before the accident, he changed the oil and replaced the oil filter. When he removed the engine cowling, there was no indication of an oil leak. After the oil change, the pilot started the engine and ran it up to average temps (oil pressure was 75 pounds per square inch) and then shut it down. When he inspected for leaks, he did not locate any. The new oil filter was safety-wired.

Postaccident examination of the airplane revealed extensive thermal damage, especially in the engine and cockpit area; charring of the engine mount powder coating indicated that the fire was more significant on the left side of the airplane. About 13 gallons of aviation fuel was present in the left tank and about 6 gallons was in the right tank. Due to extensive thermal damage to the engine and its surrounding area, it was not possible to determine the exact origin of the fire.

On May 6, 2020, Van’s Aircraft released a service bulletin that warned about the potential leaking of Kavilco pressure sensors, whihc are commonly used in fuel, oil, and manifold pressure applications on all RV models. The exact cause (manufacturing, installation, fatigue etc.) of the Kavilco pressure sensors failures has not been determined. The accident airplane was equipped with an aluminum manifold located on the upper left side of the aircraft’s firewall, which was where both the oil and fuel pressure sensors were mounted. The manifold and both sensors were destroyed by the fire.