N7009H

Substantial
None

Piper J3CS/N: 20254

Accident Details

Date
Sunday, October 27, 2019
NTSB Number
ERA20LA023
Location
Grand Bay, AL
Event ID
20191031X84231
Coordinates
30.568889, -88.377220
Aircraft Damage
Substantial
Highest Injury
None
Fatalities
0
Serious Injuries
0
Minor Injuries
0
Uninjured
2
Total Aboard
2

Probable Cause and Findings

A loss of engine power during initial climb due to carburetor ice that formed during an extended ground delay, and the pilot's failure to use carburetor heat before initiating the takeoff.

Aircraft Information

Registration
Make
PIPER
Serial Number
20254
Engine Type
Reciprocating
Year Built
1946
Model / ICAO
J3CJ3
Aircraft Type
Fixed Wing Single Engine
No. of Engines
1
Seats
2
FAA Model
J3C-65

Registered Owner (Current)

Name
EGMOND AIRCRAFT LLC
Address
16192 COASTAL HWY
City
LEWES
State / Zip Code
DE 19958-3608
Country
United States

Analysis

On October 27, 2019, about 1600 central daylight time, a Piper J3C-65, N7009H, was substantially damaged when it was involved in an accident near Grand Bay, Alabama. The airline transport pilot and passenger were not injured. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 personal flight.

The pilot stated that a preflight inspection and engine run-up revealed no anomalies; he checked the carburetor heat and the engine power decreased 50 rpm. Because of the short taxi time, he allowed the engine to warm up for about 5 minutes before initiating takeoff.

When the airplane was about 40 ft above ground level, it "seemed to quit climbing" and the engine rpm was decreasing. He pushed the throttle full forward, verified the carburetor heat was off and the fuel shutoff valve was on. He added that the engine was not running rough and was not spitting and sputtering. When he realized that the airplane would be unable to clear trees and powerlines ahead, he aborted the takeoff and slipped the airplane to lose altitude. He touched down about 100 ft before the end of the runway and was unable to stop the airplane before going off the end. The airplane continued through a wooden fence and came to rest on the other side of the fence.

Postaccident examination of the engine was performed by a Federal Aviation Administration airworthiness inspector. Impact damage to the induction manifold assembly, propeller, and both main landing gear precluded an operational test of the engine. Although the inspector had limited tools available to perform the examination and the resting position of the engine precluded 360° rotation of the propeller, the inspector reported no discrepancies with the valve train, air induction, exhaust, and fuel supply system components. The carburetor heat cable was intact and connected, but could not be operationally tested due to impact damage. The engine oil was approximately 4 quarts (normal capacity). The inspector did not remove the spark plugs, check the timing of the magnetos, or check their functionality. A sufficient quantity of fuel was noted in the fuel tank and a check of the fuel strainer revealed no contaminants.

At 1556, the weather reported at Mobile Regional Airport Field (MOB), about 10 miles northeast of the accident site, included a temperature of 22°C (72°F) and a dewpoint of 13°C (55°F). The calculated relative humidity at this temperature and dewpoint was about 58 percent. Review of the icing probability chart contained within Federal Aviation Administration Special Airworthiness Information Bulletin CE-09-35 revealed the atmospheric conditions at the time of the accident were "conducive to serious icing at glide [idle] power."

Data Source

Data provided by the National Transportation Safety Board (NTSB). For more information on this event, visit the NTSB Records Search website. NTSB# ERA20LA023