N2056V

On June 28, 2022, about 1146 Pacific daylight time, a Cessna 120, N2056V, was substantially damaged when it was involved in an accident near San Carlos, California. The pilot and passenger were not injured. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 personal flight.

The accident pilot reported that 2 days before the accident the airplane was flown, uneventfully, by another pilot from Anderson, California, to San Carlos Airport (SQL), San Carlos, using the right fuel tank. The pilot who previously flew the airplane reported that he had refueled the airplane with 15 gallons of fuel and flew it back to SQL using the right fuel tank; he estimated the duration of that flight as about 1 hour and 40 minutes. He did not indicate that the tanks had been completely filled, noting that 15 gallons was all he needed for the flight. As he approached SQL, he switched to the left fuel tank and landed uneventfully.

On the day of the accident, the accident pilot reported he had 14 gallons of fuel onboard. He taxied out to the runway using the right fuel tank, which he recalled was full of fuel. Following an engine runup, he departed runway 30. As the airplane was about 400 ft above ground level, the engine rpm decayed to about 1,800. The pilot performed a 180° turn to runway 12 but was unable to make it to the runway and landed on the airport perimeter road. The airplane bounced, impacted the fence, and came to rest upright on the airport transient parking ramp. The pilot stated that, after the accident, the right fuel line was “severed” with “pouring out fuel.” He reported that he attempted to turn the fuel selector off but instead turned it in the wrong direction before leaving the wreckage.

The accident airplane is equipped with two 12.5-gallon fuel tanks, both of which have float-type sight gauges. The fuel selector valve has three positions: LEFT, RIGHT, and OFF. The airplane owner’s manual states in part “…Set fuel tank selector to fullest tank. (Do not take off on less than 1/4 tank).”

Postaccident examination of the airplane by a Federal Aviation Administration inspector revealed that the fuselage was substantially damaged.

Examination of the recovered airframe and engine revealed no evidence of any preexisting mechanical malfunction that would have precluded normal operation. The position of the fuel selector valve at the time of the accident was unable to be determined.

The investigation did not identify any specific performance information for the O-200-A engine installed on the Cessna 120 specifically for fuel burn. However, the Fuel Flow Limits vs RPM chart from the O-200-A overhaul manual indicated that fuel burn rates vary between 4.5 and 9 gallons per hour (GPH) at 2,050 and 2,750 rpm respectfully. Fuel burn at 2,350 rpm would be about 6 gph.