CU-A1885

HISTORY OF FLIGHTOn November 14, 2022, about 1330 eastern standard time, an Antonov AN2 airplane, Cuban registration CU-A1885, was substantially damaged when it was involved in an accident near Opa-Locka, Florida. The pilot and copilot were not injured. The airplane was operated as a public aircraft ferry flight.

On October 21, 2022, a pilot seeking asylum in the United States departed Sancti Spiritus Airport (MUSS), Sancti Spiritus, Cuba, and landed at Dade-Collier Training and Transition Airport (TNT), Miami, Florida.

After landing at TNT, the pilot was detained, and the airplane was taken into custody by United States Customs and Border Protection (CBP). Custody of the airplane was transferred to a national seized property contractor, who then hired a subcontractor to move the airplane. The subcontractor determined that the airplane was airworthy and decided to fly it from TNT to Fort Lauderdale Executive Airport (FXE), Fort Lauderdale, Florida, where it could be stored in a secure facility.

The pilots performed a preflight inspection and engine runup before departing TNT about 1306. After a few minutes of flight, the pilot noticed that the airplane was smoking more than normal.

The pilots continued the flight and were flying over a canal that ran through the Everglades with a levee on the east side of the canal. About 1325, the engine started to lose power, and its airspeed and altitude began to decrease. About 1330, when the airplane was about 15 miles west of Miami-Opa Locka Executive Airport (OPF), Miami, Florida, the pilot aligned the airplane with the levee and touched down on the main landing gear. As the tailwheel was about to touch down, the airplane turned to the left, and the pilot was unable to keep the airplane on the levee. The airplane then rolled down the bank on the side of the levee, contacted the water, nosed over, and came to rest inverted in water and vegetation. PERSONNEL INFORMATIONPilot

The pilot held an airline transport pilot certificate with a rating for airplane multi-engine land, and commercial privileges for airplane single-engine land and rotorcraft-helicopter. He also possessed type ratings in the DA-10, DA-50, DA-200, EA-500S, G-100, G-1159, G-IV, HS-125, IA1125, IA-JET, and LR-Jet, with the G-100 and IA-1125 being for second-in-command privileges only.

He reported that he had accrued about 16,000 total hours of flight experience, none of which was in the accident airplane make and model.

Copilot

The copilot held an airline transport pilot certificate with a rating for airplane multi-engine land, and possessed type ratings for the G-IV, GIV, and LR-60, with the type ratings for the G-IV and LR-60, being for second-in-command privileges only.

She also held a private pilot certificate with ratings for airplane single-engine land and airplane multi-engine land, which was issued on the basis of her Argentinian private pilot license. She reported that she had accrued about 3,000 total hours of flight experience, none of which was in the accident airplane make and model. AIRCRAFT INFORMATIONThe accident airplane was a single-bay biplane equipped with conventional (tailwheel type) landing gear and was configured for agricultural spraying.

The airplane was powered by a 987-horsepower Shvetsov ASz-62 IR geared, 9-cylinder radial engine driving a 4-blade AW-2 propeller.

According to information provided by the Republic of Cuba, the airplane was manufactured in 1982. The airplane's most recent continuous airworthiness inspection was completed on July 7, 2022. At the time of the inspection, the airplane had accrued about 7,190 total hours of operation, and the engine had accrued approximately 600 hours of operation since major overhaul. METEOROLOGICAL INFORMATIONThe recorded weather at OPF about 47 minutes after the accident, included wind from 080° at 9 kts, 10 miles visibility, few clouds at 3,900 ft above ground level, temperature 28°C, dew point 20°C, and an altimeter setting of 30.01 inches of mercury. AIRPORT INFORMATIONThe accident airplane was a single-bay biplane equipped with conventional (tailwheel type) landing gear and was configured for agricultural spraying.

The airplane was powered by a 987-horsepower Shvetsov ASz-62 IR geared, 9-cylinder radial engine driving a 4-blade AW-2 propeller.

According to information provided by the Republic of Cuba, the airplane was manufactured in 1982. The airplane's most recent continuous airworthiness inspection was completed on July 7, 2022. At the time of the inspection, the airplane had accrued about 7,190 total hours of operation, and the engine had accrued approximately 600 hours of operation since major overhaul. WRECKAGE AND IMPACT INFORMATIONAirplane

Examination of the accident site revealed evidence consistent with the main landing gear being too wide for the airplane to land on the levee, and damage consistent with the airplane having traveled off the left side of the levee, nosing over, and coming to rest inverted.

The right lower wing and right upper wing sustained impact, crush, and compression damage outboard of the interplane strut. The left lower wing incurred substantial damage to its structure about 4 ft outboard of the wing root, with the wing bent downward from its usual mounting location. The left upper wing also received substantial damage to its internal structure and was bent aft outboard of the wing root. The vertical stabilizer was damaged.

The fuel found in the gascolator was bright blue in color and had an odor consistent with 100LL aviation gasoline. When water-finding paste was introduced, no evidence of contamination was indicated.

Further examination of the airplane also revealed a large amount of oil aft of the engine bay.

Propeller and Engine

None of the four propeller blades displayed evidence of leading-edge gouging, chordwise scratching, or S-bending. Only two of the propeller blades showed minimal aft bending, consistent with little or no power upon ground contact.

Examination of the cylinders with a borescope did not reveal any damage to the cylinder walls or tops of the pistons. The piston skirts could not be viewed.

Oil System

The oil system consisted of a tank, oil cooler, pipes, fittings, and an oil pump. Oil was drawn from the oil tank by the oil pump and pumped to the engine. After circulating in the engine, oil was drawn out of the engine by the same pump and pumped back to the oil tank.

While circulating from the engine to the oil tank, oil passed through the oil cooler. The oil cooler was mounted under the airplane’s fuselage and was surrounded by a tunnel with electrically-controlled shutters that could be opened to increase airflow through the oil cooler or closed to decrease airflow through the oil cooler.

Examination of the oil system revealed the presence of metal contamination inside the main engine oil filter, oil pump filter, and two other oil strainers. Use of a magnetic probe indicated that some of the particulate was ferrous (steel or iron). The shutters for the oil cooler were found in the closed position.

Engine Cowling

The engine cowling was equipped with cowl flaps which, when opened, would increase the airflow through the engine compartment and around the cylinder cooling fins. When closed, they would reduce the amount of cooling air flowing through the cowling and around the cylinder cooling fins. The cowl flaps were found in the closed position.

Cockpit

Examination of the cockpit revealed that the instruments and switches were labeled in Cyrillic script. Further examination also revealed that the airplane was equipped with a cylinder head temperature (CHT) gauge that would react more quickly than an oil temperature gauge.

Two switches were located next to each other on the aft right upper surface of the “central control desk.” One controlled the oil cooler shutters and the other controlled the cowl flaps. Both switches were found in the off/closed position. ADDITIONAL INFORMATIONWitness Video

Review of videos taken of the engine runup and takeoff indicated that the cowl flaps were closed while the airplane was on the ground and during the takeoff from TNT.

Video of the flight shot from a helicopter indicated that the smoke that began to emanate from the airplane before the accident was consistent with oil smoke.

NTSB Interview

The pilot was interviewed at FXE by the NTSB and FAA on December 6, 2022. He stated that he had been flying for the contractor for years and the contractor had asked him to fly the accident airplane from TNT to FXE. Both he and the copilot were being paid for the flight.

He traveled to TNT about a week before the accident and made sure there was fuel in the airplane and oil in the engine. He then ran up the engine.

He then came back on another day, but cancelled the flight due to the wind conditions.

On the day of the accident, he started the engine, then took off from runway 9, flew over a levee, and was cruising at 600 feet. About 15 minutes after takeoff, he realized that he was going to have to land on the levee, as the engine began to blow more smoke than normal and was losing power. At 200 feet, the engine lost power completely and after landing on the levee, the airplane went off the side of the levee and nosed over.

When asked about the preflight, the pilot advised that he had conducted three different preflight inspections (once each time he had traveled out to TNT). When asked if he used a checklist each time, he responded no, and that he just used common sense.

When asked about the airplane flight manual he used, he advised that it was in Spanish, but the airplane was labeled in Russian, so his copilot translated what the labeling in the cockpit said. The manual had airspeeds listed in miles per hour, but the airplane was marked in kilometers per hour; the crew also only had pieces of the manual that were sent by a friend in Argentina. The pilot did not know if it was an official flight manual.

When asked about the runups, he a...