N8360K

HISTORY OF FLIGHTOn October 3, 2023, about 1847 Pacific daylight time, a Piper PA-44-180, N8360K, was substantially damaged when it was involved in an accident near Newberg, Oregon. The flight instructor and the pilot receiving instruction were fatally injured; a pilot-rated rear-seated passenger was seriously injured. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 instructional flight.

A representative from the operator reported that the pilot receiving instruction had recently obtained a commercial pilot certificate with an airplane single-engine land rating and the accident flight was his first flight in his multi-engine training program. They added that it is common for the first multi-engine training flight to include slow flight, power-off stalls, power-on stalls, accelerated stalls, steep turns, and a Vmc demonstration.

The pilot-rated passenger reported that she had recently completed ground training for her multi-engine rating, and on the day of the accident flight, she had been invited to observe the multi-engine training session. During the accident flight, she was seated in the rear right seat, behind the flight instructor. With the pilot receiving instruction flying the airplane, she observed a series of maneuvers, including slow flight, emergency descent, steep turns, and stalls, followed by a Vmc demonstration. Unable to see all the airplane’s flight controls from her position, she believed the airplane’s left engine was set to idle, the landing gear was retracted, and the flaps were in a cruise configuration. During the Vmc demonstration, the stall warning sounded, and the airplane almost immediately went inverted to the left. Initially, the pilot receiving instruction remained on the flight controls, verbalizing the steps he was taking to try to stop the spin, but she could not understand what he was saying. The pilot receiving instruction then asked the flight instructor to take control of the airplane, which he did. The pilot receiving instruction then asked the flight instructor if he should run a checklist, and the flight instructor replied “yes.” In the final seconds it became clear to the passenger that they were not going to recover and that they were going to crash. She did not recall impacting terrain. The pilot-rated passenger was not aware of any mechanical issues, but she did not participate in the preflight inspection of the accident airplane. During the accident flight, she did not notice any mechanical defects.

ADS-B data showed that the airplane departed Portland-Hillsboro Airport (HIO) at 0118:21 and ascended to 1,200 ft msl before entering a left turn. The airplane continued on a westerly heading and ascended to an altitude of about 3,400 ft msl. At 0125:35 the airplane made a left turn to the south and ascended to an altitude of 5,300 ft msl. At 0130:46 the airplane made a left 180° turn to the north, then made a right turn to the northeast. The data showed the airplane continued on a northeast heading for about 3 minutes before a series of 360° turns to the left and right were performed. At the completion of the turns, the airplane turned to the southwest. The data showed that at 0143:48, the airplane made a left turn to the southeast. While on a southeasterly heading, the airplane’s ground speed began to decrease from 133 kts. At 0145:56 the data showed the airplane’s ground speed had decreased to 69 kts, at an altitude of 5,750 ft msl, and began to descend on a southeasterly heading. The last recorded ADS-B target, at 0146:38, was located about 50 ft northwest of the accident site at an altitude of 525 ft, as seen in Figure 1.

Figure 1: View of accident airplane flight track.

According to multiple witnesses near the accident site, the airplane was in level flight before it pitched downward and entered a near-vertical descent. The airplane continued in a nose-low, near-vertical descent until the airplane went out of visual range. Several witnesses described the airplane as “spinning” or “spiraling” during various phases of the vertical descent. Video recorded by one of the witnesses shows the airplane spiraling as it descended. AIRCRAFT INFORMATIONThe airplane was equipped with a J. P. Instruments EDM-960 that can monitor and record multiple engine parameters related to twin-engine operations. The engine monitor was removed and sent to the National Transportation Safety Board’s (NTSB) Vehicle Recorder Laboratory. The memory chip was removed from the impact-damaged unit and the data was downloaded from the EDM. The downloaded engine data included 44 sessions from July 21, 2023, to October 3, 2023. The last recorded session was identified as the accident flight. The accident recording was 48 minutes and 48 seconds long and ended shortly before the aircraft impacted terrain. The downloaded EDM data indicated the following sequence of events:

• 18:17:20 PDT: The aircraft began takeoff roll

• 18:22:20 PDT: Pressure altitude was 4072 ft

• 18:29:08 PDT: The aircraft began to climb from 4354 ft

• 18:38:20 PDT: The aircraft began a descent from 7091 ft

• 18:44:50 PDT: Engine revolutions per minute (rpm) left and right were 2358 rpm and 2366 rpm, respectively. Engine Manifold Pressure (MAP) left and right were 22.5 inHg and 22.4 inHg, respectively. Fuel flow left and right were 10.4 gph and 10.2 gph, respectively.

• 18:44:56 PDT: RPM left and right were 2335 rpm and 2326 rpm, respectively. MAP left and right were 16.1 inHg and 17.3 inHg, respectively. Fuel flow left and right were 9.1 gph and 9.4 gph, respectively.

• 18:45:08 PDT: RPM left and right were 2540 rpm and 2457 rpm, respectively. MAP left and right were 14.2 inHg and 14.7 inHg, respectively. Fuel flow left and right were 7.1 gph and 7.6 gph, respectively.

• 18:45:26 PDT: RPM left and right were 1495 rpm and 2639 rpm, respectively. MAP left and right were 4.5 inHg and 24.1 inHg, respectively. Fuel flow left and right were 1.7 gph and 10.4 gph, respectively.

• 18:45:56 PDT: Pressure altitude was 5816 ft. RPM left and right were 840 rpm and 1947 rpm, respectively. MAP left and right were 6.7 inHg and 4.4 inHg, respectively. Fuel flow left and right were 3.4 gph and 12.7 gph, respectively. The aircraft began to descend for the remainder of the recording.

• 18:46:20 PDT: The last recorded JPI EDM-960 data point. Pressure altitude was 4796 ft. RPM left and right were 0 rpm and 497 rpm, respectively. MAP left and right were 26.5 inHg and 12.2 inHg, respectively. Fuel flow left and right were 1.2 gph and 5.5 gph, respectively. AIRPORT INFORMATIONThe airplane was equipped with a J. P. Instruments EDM-960 that can monitor and record multiple engine parameters related to twin-engine operations. The engine monitor was removed and sent to the National Transportation Safety Board’s (NTSB) Vehicle Recorder Laboratory. The memory chip was removed from the impact-damaged unit and the data was downloaded from the EDM. The downloaded engine data included 44 sessions from July 21, 2023, to October 3, 2023. The last recorded session was identified as the accident flight. The accident recording was 48 minutes and 48 seconds long and ended shortly before the aircraft impacted terrain. The downloaded EDM data indicated the following sequence of events:

• 18:17:20 PDT: The aircraft began takeoff roll

• 18:22:20 PDT: Pressure altitude was 4072 ft

• 18:29:08 PDT: The aircraft began to climb from 4354 ft

• 18:38:20 PDT: The aircraft began a descent from 7091 ft

• 18:44:50 PDT: Engine revolutions per minute (rpm) left and right were 2358 rpm and 2366 rpm, respectively. Engine Manifold Pressure (MAP) left and right were 22.5 inHg and 22.4 inHg, respectively. Fuel flow left and right were 10.4 gph and 10.2 gph, respectively.

• 18:44:56 PDT: RPM left and right were 2335 rpm and 2326 rpm, respectively. MAP left and right were 16.1 inHg and 17.3 inHg, respectively. Fuel flow left and right were 9.1 gph and 9.4 gph, respectively.

• 18:45:08 PDT: RPM left and right were 2540 rpm and 2457 rpm, respectively. MAP left and right were 14.2 inHg and 14.7 inHg, respectively. Fuel flow left and right were 7.1 gph and 7.6 gph, respectively.

• 18:45:26 PDT: RPM left and right were 1495 rpm and 2639 rpm, respectively. MAP left and right were 4.5 inHg and 24.1 inHg, respectively. Fuel flow left and right were 1.7 gph and 10.4 gph, respectively.

• 18:45:56 PDT: Pressure altitude was 5816 ft. RPM left and right were 840 rpm and 1947 rpm, respectively. MAP left and right were 6.7 inHg and 4.4 inHg, respectively. Fuel flow left and right were 3.4 gph and 12.7 gph, respectively. The aircraft began to descend for the remainder of the recording.

• 18:46:20 PDT: The last recorded JPI EDM-960 data point. Pressure altitude was 4796 ft. RPM left and right were 0 rpm and 497 rpm, respectively. MAP left and right were 26.5 inHg and 12.2 inHg, respectively. Fuel flow left and right were 1.2 gph and 5.5 gph, respectively. WRECKAGE AND IMPACT INFORMATIONExamination of the accident site revealed that the airplane impacted a single-story residential structure, substantially damaging the fuselage and wings. The airplane came to rest in a near-vertical attitude in the residential structure, on a heading of about 285° magnetic and at an elevation of 249 ft msl. No visible ground scars were observed surrounding the wreckage. All major structural components of the airplane were located within about 10 ft of the main wreckage.

Postaccident examination of the recovered airframe and engines did not reveal evidence of any mechanical anomalies that would have precluded normal operation. Flight control continuity was established from the cockpit to all primary flight controls. Numerous separations were noted within the flight control system with signatures consistent with overload separation or due to the recovery process. ADDITIONAL INFORMATIONAccording to the FAA Airplane Flying Handbook (FAA-H-8083-3C), Vmc is the minimum control speed with the critical en...