N1500D

Substantial
None

CESSNA 190S/N: 7722

Accident Details

Date
Friday, May 17, 2024
NTSB Number
ANC24LA036
Location
San Luis Obispo, CA
Event ID
20240521194301
Coordinates
35.237273, -120.642600
Aircraft Damage
Substantial
Highest Injury
None
Fatalities
0
Serious Injuries
0
Minor Injuries
0
Uninjured
2
Total Aboard
2

Probable Cause and Findings

The pilot’s failure to maintain directional control during the landing roll, which resulted in a failure of the right main landing gear and subsequent ground loop.

Aircraft Information

Registration
Make
CESSNA
Serial Number
7722
Engine Type
Reciprocating
Year Built
1951
Model / ICAO
190C190
Aircraft Type
Fixed Wing Single Engine
No. of Engines
1
Seats
5
FAA Model
190

Registered Owner (Current)

Name
MAXSON LEE V
Address
7825 E MCDOWELL RD
City
MESA
State / Zip Code
AZ 85207-1224
Country
United States

Analysis

On May 17, 2024, about 1500 Pacific daylight time, a Cessna 190 airplane, N1500D, was substantially damaged when it was involved in an accident near San Luis Obispo, California. The pilot was uninjured. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 personal flight.

The pilot reported that, during the landing roll on runway 29 at San Luis Obispo County Regional Airport (SBP), San Luis Obispo, the airplane’s right main gear began to track under the fuselage. As the airplane slowed, he was unable to maintain directional control, which resulted in a ground loop, substantially damaging the right wing.

Following the accident, the pilot examined the airplane’s right main landing gear and found the bolts attaching the axle to the main gear spring had fractured. The fractured bolt allowed the right main wheel assembly to separate from the right main landing gear spring.

The right main landing gear axle, tapered shim, and attachment bolt were collected and submitted to the National Transportation Safety Board’s Materials Laboratory in Washington, DC, for examination.

The two fractured lower bolt shafts were retained in the axle. The tapered shim was bent and buckled outboard, downward, and slightly aft. Two curved witness marks were observed near the lower edge of the tapered shim. These witness marks were aligned with the hole features on the mating axle collar surface. The fractured bolt shafts retained in the axle exhibited a relatively rough, matte gray fracture surface morphology.

Radial features were observed emanating from a thread root at the upper edge of both bolts over a relatively flat fracture surface through approximately 40% of the bolt cross section, at which point the fracture continued downward along an outboard and slightly aft slanted plane through the remainder of the bolt. The relatively flat fracture surface at the top of the bolt was consistent with overstress fracture from a downward bending load before the final fracture in downward and slightly aft bending.?

Data Source

Data provided by the National Transportation Safety Board (NTSB). For more information on this event, visit the NTSB Records Search website. NTSB# ANC24LA036